Spiral secondary structure concrete pouring machine Electric fine stone conveyor Dragon type loader

How to operate a small loading machine. Check the appearance of the machine to see if it is damaged due to long-distance transportation, especially the electrical appliances in the electrical box and the wires have not fallen off.
.Connect the power supply and the equipment shell should be grounded for protection. Start the motor to see if it can work normally.
3. Place it in the hopper, insert a 1-meter or 1-meter winch cage according to the construction height and angle, and the joint angles of the upper and lower blades should be aligned according to the spiral angle. Then install the ash outlet. Finally tighten the buckle.
.The cage inside the pipe. (The height of the winch from the top is higher than the height of the column or lintel to be poured.) Push it to the construction point, and extend the ash outlet hose into the ash inlet hole of the column.
.When starting to use, the pipes should be moistened with thin ash first, and the remaining ash in the pipes should be discharged, and then the hopper, ash pipes, etc. should be cleaned.
Precautions for small loading machines
. Must be rubbed under the leakage protector
. The interval between reverse and forward rotation must be more than seconds
3. Pay attention to stability when moving to avoid the side of the machine Inadvertently injuring people and breaking things.
.When stopping the machine, the remaining materials must be discharged and the machine must be cleaned with water.
Remarks: If the product does not load or feeds slowly
Troubleshooting during operation:
If the winch is often stuck, it is usually because the groove belt is loose and needs to be adjusted to the tightening level.
.The power supply must be reliably grounded and equipped with a leakage protection device. When dusting, be careful not to expose the electrical box to water or operate it with wet hands.
3. When the hanging cage is stuck, start the reverse and then run forward.
., pay attention to the two universal bearings not to be covered with dust, and add butter to the bearings every week.
.. The dusting height can be adjusted with the connector provided with the machine. When adjusting, it should be installed at the bell mouth connection.
Additional knowledge:
What is a quadratic structure?
In frame, shear wall, frame shear projects, some non-load-bearing masonry, structural columns, lintels and other parts that need to be completed before decoration are called secondary structures.
Scope editing is constructed after the construction of the primary structure (referring to the load-bearing component part of the main structure) is completed. It is relative to the load-bearing structure, which is a non-load-bearing structure and envelope structure, such as structural columns and lintels. , water-stop reverse beams, parapets, roofing, infill walls, partition walls, etc.
The difference between primary structure and secondary structure
Structural columns are secondary structures. Some are indicated as structural columns on the design drawings, but they are all cast after the main body is closed and the formwork is closed. They also belong to secondary structure. The structural columns that are not on the drawings and require the technical person in charge to point out the positions of the structural columns are secondary structures and are used in masonry structures to enhance the integrity and seismic performance of the masonry structure.
Jining Dingcheng Industrial and Mining Equipment Co., Ltd.
Contact person: Zhang Wenfeng
Mobile phone
WeChat:
Landline
Fax:
: