Inspection well mold Guoqing mold factory wholesale and retail

抗压：

%

耐磨：

%

抗变形：

%

As the name suggests, the inspection well mold is a mold that exists for the construction of inspection wells. So what exactly are inspection wells used for? Inspection wells are used to check the underground infrastructure of the entire city as well as infrastructure problems such as power supply, water supply, cable TV, gas pipes, drainage, sewage, communications, street lights, etc. It can also be said that it is built for the convenience of installation of urban infrastructure. The place where it is built is also relatively particular. It should be convenient for regular inspection of surrounding public facilities, such as at pipeline intersections, turns, or where pipe diameters or slopes change. So what is the most reasonable size for us to build inspection wells? First, let’s talk about how far away the inspection well should be buried from the surface. Generally speaking, it is most appropriate for the inspection well to be buried no more than a distance from the surface. If it is too close to the surface, it will easily cause damage to the inspection well and is not conducive to the long-term use of the inspection well. If it is buried too deep in the ground, it will not be conducive to construction and will also have a certain impact on power and water conservancy. The diameter of the inspection well should be such that it can first ensure the access of maintenance personnel and ensure the stability of the well body, which is not easy to deform and collapse. Inspection wells not only have requirements for the diameter of the wellhead and the number of meters buried on the surface. The most important point is that inspection wells also have very strict requirements for the well wall. The well wall must be thick and should not be too thin. This is mainly because the service life of the inspection well has a certain limit. Therefore, it must have the characteristics of strong stability and corrosion resistance. The inspection well consists of a well seat, a well shaft, a manhole cover and related accessories. Next, let's talk about the molding process of the inspection well mold. The plastic integrated injection molding inspection well refers to the main part of the inspection well, the well base, which adopts a one-time injection molding process. In this way, the well base has higher pressure resistance. Strongly conducive to the construction of inspection wells. The wellbore socket adopts a circular-type load-bearing platform. The bottom of the wellbore and the well base adopts mesh reinforcement ribs. Each socket adopts an annular reinforcement design. This is mainly because the underground pressure is strong and relatively moist. Only in this way is it beneficial to the wellbore part. It will not deform for many years under the surface and has strong corrosion resistance. It can also be classified into different categories according to the number of joints and the angle of the well body, such as straight-through well seats, elbow well seats, three-way well seats, four-way well seats, starting well seats, etc. This is done to allow the manhole body to adapt to a variety of drainage conditions. With the continuous development of my country's economic level and science and technology, the mold industry is also making continuous progress. In response to the country's call for sustainable development, inspection well molds have been using a new type of building materials equipment this year. Its characteristic is that it consumes less energy and is conducive to protecting the environment. Further conserve resources and jointly create a friendly new society.