Soybean machine—drying characteristics—Guangzhou Benchuang Mechanical Soybean Dryer

1. Introduction
After drying and peeling soybeans, the soaking time of watercress can be greatly shortened, and the chance of decomposition and destruction of soybean protein by the inherent proteases and foreign bacteria of watercress can be reduced, resulting in a high product yield. Soy milk, soy milk, bean curd (tofu curd) and tofu produced from peeled watercress have a pure, rich flavor and no bitter taste. Using peeled bean curd to produce yuba, soybean oil skin and tofu not only has a high output rate, but also has good toughness and good taste. The yuba is resistant to cooking and soaking and has excellent quality, resulting in large sales, high selling prices and high profits.
2. Characteristics
Adopting a horizontal drum design, the drum has a large volume, so the output is high, which greatly shortens the production time. The inclined scraper screw propeller (commonly known as an auger) can make the material turn up and down, front and back and heated very evenly. .
The electric rotating and tumbling material will be automatically discharged when the discharge door is opened. There is a thermometer to measure the temperature of the material in order to control the heating power. The yuba factories in Jiangmen area all use our soybean dryer (the one-time loading capacity of the soybean dryer must be large because although the higher the drying temperature, the shorter the drying time, but it cannot exceed a certain temperature, otherwise the protein will be denatured and ground. It will not form pulp, so the drying time for each batch should be at least tens of minutes).
Three major advantages are distinctive: ①. Using a large-diameter, vertical round pipe as the feed funnel of the drum can prevent the soybeans coming off the elevator from splashing (bouncing) out. (When the elevator is working, the speed of the material entering the hopper is lower than the speed of the material entering the drum, so there is always no material in the hopper.) ②. A blower is provided to continuously blow in fresh air and discharge water vapor to accelerate the drying of the material. Save fuel and shorten drying time
It can burn wood, sawdust and coal, etc., and use industrial boiler flue gas or steam as heat energy to generate hot air through the heat exchanger (a hot air inlet has been reserved during manufacturing) nozzle) for heating and drying.
National free consultation hotline: -
Mobile phone: Manager Yuan
WeChat ID:
Company landline:
Fax:
:
:
Email: @.
After-sales service:
Company address: Xia Industrial Area Code, Longgui Garden, Baiyun District, Guangzhou