Veken Heavy Industry's development of crusher equipment attracts attention

The development of crusher equipment by Veken Heavy Industry has attracted attention. The application range of crusher equipment is very wide. Traditional stones such as river pebbles, granite, quartz, and glass construction waste can all use crusher equipment. Secondly, the feed size of the crusher equipment is large and there are not many requirements for materials. Finally, the crusher equipment adopts a double-chamber rotor, which greatly improves the production capacity of the crusher equipment, reduces the wear rate, and achieves clogging-free production. Purchase crusher equipment and consult the crusher price from Veken Heavy Industry! General precautions: The operating point of the impact crusher equipment is stable. When the vibration of the machine increases, the machine should be stopped immediately to find out the cause and eliminate it. Under normal circumstances, the temperature rise of the bearing should not exceed the limit, and the maximum temperature should not exceed the limit. If it exceeds the limit, the machine should be stopped immediately to find out the reason. When the plate hammer wear reaches the limit mark, it should be turned around or replaced in time. After installing or replacing the plate hammer, the rotor must be kept balanced and the static balance must not be exceeded. When the rack lining is worn, it should be replaced in time to avoid wear on the chassis. Check the tightening status of all bolts before starting the machine every time.

Opening and closing of the rear upper cover. When the frame lining, impact lining, plate hammer and other wearing parts need to be replaced after wear, or when the impact crusher breaks down and needs to be eliminated, the ratchet device is used to open and close the upper cover. Close the rear upper cover for replacement and maintenance. Before opening the cover, unscrew the locking nuts and bolts, and then place spacers on the lower ends of the upper cover arms. When opening, people need to operate together, pull the ratchet device, and the upper cover will slowly open. When the opening is close to the end, the lower end pad should contact the lower end slope of the arm in advance to ensure safety and reliability.

After replacement or maintenance is completed, the small handle on the ratchet device can be operated jointly by people to slowly close the rear upper cover. Before closing the rear lid, the sealing surface needs to be completely sanitary. Always pay attention to and promptly perform lubrication work on conflict surfaces. The lubricating oil selected for this machine should be determined according to the location where the crusher machine is used, temperature and other conditions. Calcium-sodium based lubricating oil can usually be used. Add lubricating oil to the bearing after every eight hours of operation, and replace the lubricating grease every three months. When changing the oil, use clean gasoline or kerosene to clean the bearing carefully, and add % of the volume of lubricating grease in the bearing seat.
Cone crusher equipment:: b/
Vibrating feeder:: b/r
Circular vibrating screen price:: b/r