Graphite GZD vibrating feeder

series vibrating feeder is also called vibrating feeder. The vibrating feeder developed and produced by Shanghai Minggong uses a vibration motor as the excitation source to ensure that the equipment can withstand the impact of falling large materials. The feeding capacity is greatly improved and is used in coarse crushers. The front large pieces of material are evenly supplied and at the same time, the function of the bar or plate mesh screen surface can be used to achieve the pre-screening function to remove soil and fine-grained materials. In the sand and gravel production process, block and granular materials can be removed from The material in the storage silo is evenly, regularly and continuously fed to the receiving device, thereby preventing the receiving device from crashing due to uneven feeding and extending the service life of the equipment. Vibrating feeders can be divided into steel plate structure and grate structure. Feeders with steel plate structure are mostly used in sand and gravel production lines to feed all materials evenly into the crushing equipment. Vibrating feeders with grate structure can coarsely screen materials to make the system More economical and reasonable preparation is an indispensable equipment in crushing and screening. Vibrating feeders are used in combined crushing and screening equipment operations in metallurgy, coal mines, mineral processing, building materials, chemicals, abrasives and other industries.
.>This series of vibrating feeders has a simple structure, uniform feeding, continuous performance, good performance, and the excitation force can be adjusted to change and control the flow rate at any time. The eccentric block is the excitation source. The eccentric block is the excitation source. It has low noise, low power consumption, good adjustment performance, and no rush phenomenon. If the closed body is used, dust pollution can be prevented, the vibration is stable, the operation is reliable, and the service life is long. When configuring and designing the equipment according to the performance requirements, the pressure of the material on the tank should be minimized. According to the manufacturer's requirements, the effective discharge port of the warehouse material should not be larger than one-quarter of the tank width. The flow rate of the material should be controlled within a certain limit for materials with a large feeding amount. The ore blocking plate of sufficient height should be installed at the discharge position at the bottom of the bin so as not to affect the performance of the feeder. The ore blocking plate should not be fixed on the tank body. In order to enable the silo to be discharged smoothly, the inclination angle of the rear wall of the silo is best designed to be - degrees.
.>Working principle of vibrating feeder:
.>D series vibrating feeder is composed of feeding trough, vibrator, spring support, transmission device, etc. The vibration source of the tank vibrating feed is the exciter. The exciter is composed of two eccentric shafts (active and passive) and a gear pair. The motor drives the active shaft through a triangle belt, and then the gear on the active shaft engages with the passive shaft to rotate the main and passive shafts. The passive shaft rotates in the opposite direction at the same time to vibrate the tank body so that the material flows continuously to achieve the purpose of conveying the material.