Ocean King (wholesale, retail) NSC9720 anti-glare pathway light

Ocean King anti-glare street lights
1. Scope of application
The latest development and production of mirrors to meet the anti-glare lighting needs of railway tunnels, highway bridges, public venues and various manufacturing enterprises
This anti-glare street light is widely used for flood lighting of roads and passages in tunnels, roads and bridges, large facilities, factories, stations and other places.
2. Performance characteristics
The use of protective angle design and mirror coating technology to achieve anti-glare effects can effectively reduce irritation to the eyes of workers and construction workers. Avoid discomfort and fatigue.
It is also equipped with mirror glass for customers to choose to use in different places with high brightness requirements.
Selected gas discharge light source. High light efficiency, long life, power factor is greater than. Good light transmittance, life span is up to 1 hour.
Special surface coating and sealing treatment ensure that the lamps will never corrode or rust in harsh environments such as moisture and high temperature.
Multiple shock-proof structural designs and high-strength alloy shell ensure its long-term safe operation in high-frequency vibrations such as roadbed rails, bridges and tunnels.
The illumination angle can be adjusted in a wide range of up and down according to the needs of the environment in various installation methods such as seat type, ceiling type and wall-mounted type.
3. Technical parameters
Rated voltage/
Power factor greater than
Protection level
Anti-corrosion level
Insulation level
Pitch-to-height ratio
Cable inlet thread/~
Overall dimensions #
Weight
Equipped with light source:
Order number Equipped with light source, rated power, luminous flux, average service life
-
-
-
-
-
4. How to use
Determine the installation location and method of the lamp according to the site environment and lighting needs, and then fix it and install it according to the lamp. Prepare a cable of corresponding length to the power contact point.
Unscrew the two butterfly bolts fixing the front cover on the upper part of the lamp, open the front cover, and introduce one end of the prepared cable into the lamp cavity through the compression nut of the introduction device. Wire according to the polarity marked on the terminal base, and then wire Tighten the compression nut of the introduction device.
Close the front cover and tighten the two butterfly bolts on it, then connect the other end of the cable to the power supply to light up.
When multiple lamps are used in parallel, introduce the cable from another lead-in device and wire it according to the above method, and then connect it to other lamps. When using a single lamp, plug the idle lead-in device with a plug.
. Loosen the fixing screws on both sides of the bracket to adjust the lighting angle of the lamp in the upper and lower range.
. The inside of the lamp cavity is equipped with a support rod. After opening the lamp cover, you can support it as needed.
5. How to use
When transporting, put the lamps in the provided cartons and add foam shock absorption.
. It is normal for the surface of the lamp to have a certain temperature rise during use. The center temperature of the transparent part is higher and should not be touched.
When replacing the bulb, try to use the same type of bulb. If the bulb type or power is changed, the matching ballast should be replaced accordingly.
The temperature resistance of the cables introduced into the lamp cavity should not be lower than ℃ (such as silicone rubber, polytetrafluoroethylene cables, etc.).
Warning, do not install directly on combustible materials
, Replace any cracked protective screen
, The power must be disconnected before installing and maintaining the lamp
, The lamp must be reliably grounded .
6. Quality Assurance
The company has passed: International Quality System Audit Certification. This product is produced in strict compliance with international quality management system standards to ensure that product quality fully meets national standards and design requirements. The product is subject to an annual warranty (light source and electrical appliances warranty) One year) From the date of purchase, if any malfunction occurs during normal use of the product within one year, our company will be responsible for free maintenance.