White ash ball mill

The material enters the first chamber of the white ash ball mill evenly and spirally from the feeding device through the feeding hollow shaft. There are ladder linings or corrugated linings in the white ash ball mill chamber, and steel balls of different specifications are installed inside. The rotation of the cylinder generates centrifugal force to bring the steel balls to After falling from a certain height, it will hit and grind the material hard. After the materials reach coarse grinding in the first chamber, they enter the second chamber through the single-layer partition plate. This chamber is equipped with a flat lining plate and contains steel balls for further grinding the materials. The powdery material is discharged through the discharge grate plate to complete the grinding operation
. During the rotation of the cylinder, the grinding body also slides down. During the sliding process, the material is given a grinding effect. In order to effectively utilize the grinding effect, When grinding materials with large particle size into 20-mesh grinding, the grinding cylinder is divided into two sections with a partition plate, which becomes a double warehouse. When the material enters the first warehouse, it is crushed by the steel balls, and the material enters the second warehouse. When the material is ground, the steel end grinds the material, and the qualified material is discharged from the hollow shaft at the discharge end. When the material with small feed particles is ground, such as sand No. 2 slag, coarse fly ash, and white ash, the barrel of the ball mill can be removed. Set up a partition to become a single-silo mill, and the grinding volume can also be used as a steel section
. Structural features of white ash ball mill
. Lime ball mill consists of a feeding part, a discharging part, a rotary part, and a transmission part ( Reducer, small transmission gear, motor, electronic control) and other main parts. The hollow shaft is made of cast steel with a removable inner lining. The rotating gear is hobbing from castings. The cylinder is inlaid with a wear-resistant lining plate, which has good wear resistance. This machine runs smoothly and works reliably. According to the materials and discharge method, dry ball mill and wet grid ball mill can be selected.