calcite hammer crusher

< .>Hammer Crusher r is used to crush various medium-hard and weakly abrasive materials. The compressive strength of the material does not exceed the moisture content and is less than %. The materials to be crushed are coal, salt, chalk, gypsum, bricks, limestone, etc. It is also used to break the fibrous structure, scrap wood, paper with strong elasticity and toughness, or break asbestos cement waste to recover asbestos fibers, etc. In addition
r hammer crusher
r can not only be used in the crushing production line and sand making production line, but also can replace the cone crusher in the mineral processing production line.
r. Features of hammer crusher: r: The working hammer head is cast using a new process and is wear-resistant and impact-resistant. r: .The required granularity can be adjusted according to customer requirements. r: The structural seal of the hammer crusher body solves the problem of dust pollution and ash leakage in the crushing workshop. The unit structure is convenient for transportation and installation. r: .The overall design is beautiful, the structure is compact, and there are few wearing parts and easy maintenance. The chassis of the upgraded product can be flipped for more convenient maintenance. r: .Hammer crusher (hammer crushing) has the advantages of simple structure, convenient operation, high production efficiency, low investment, etc. r:.Full impact, counterattack, and impact (rock on stone) crushing functions, high production efficiency, low wear of machine parts, and comprehensive benefits Significantly. r : r : The after-sales staff of Shanghai Minggong Equipment Co., Ltd. teaches you how to test-run the hammer crusher r : Before use, check whether each system component and auxiliary hand wheel are in the correct position, and whether the tightening screws, etc. are loose. Everything is functioning normally. r: The motor should be installed in the opposite direction to the feed port. r: Check whether there is proper lubricating oil in the bearing. r: When installing, the terrain should be selected based on the actual source of raw materials before installation. r: Gently turn the rotor by hand to see if it is normal and there is no friction. If there is no friction, you can run the rotor empty for half an hour.