Analysis of wear-resistant and anti-corrosion processing of agitator blades of Essen mixer

电源：

～380V 50HZ

功率：

37KW 变频电机

.Before spraying the wear-resistant and anti-corrosion coating on the agitator blades, the sprayed agitator blades need to be cleaned. Impurities cannot appear during the spraying process, and the integrity of the wear-resistant and anti-corrosion coating on the agitator blades must be ensured. .In the process of spraying the wear-resistant and anti-corrosion coating on the mixer blades, it is only a layer of decoration for the surface of the mixer blades. Do not spray paint that is too thick. This will cause the paint to be too thick and cause color deformation. This will not Conducive to the normal use of the mixer blades.
.When spraying the wear-resistant and anti-corrosion coating on the mixer blades, the uniformity of the paint must be ensured. The paint needs to be stirred before spraying, so that the paint can be fully integrated and the upper layer of the paint will not appear to be light. , the following appears due to a relatively turbid phenomenon.
.If the paint is too viscous during the spraying process of the wear-resistant and anti-corrosion coating of the mixer blades, additives can be used during spraying, but they need to be prepared according to the relevant proportions, and there must be no imbalance in the proportions. Phenomenon.
In fact, the most important thing is to pay attention during the spraying process of the wear-resistant and anti-corrosion coating of the mixer blades to ensure that the spraying is sufficiently uniform. The phenomenon of different thicknesses cannot occur. Paints with different thicknesses will affect the overall aesthetics and normal use of the mixer blades after spraying, causing visual disharmony.
Contact person Mr. Liu’s phone number