Analysis and introduction of Essen mixer mixer selection steps

电源：

～380V 50HZ

功率：

37KW 变频电机

The design and selection of the imitation mixing device is closely integrated with the purpose of the mixing operation. Various mixing processes need to be realized by different mixing devices. When designing and selecting, first determine the mixer type, motor power, and mixing speed according to the purpose and requirements of the mixing operation, and then select the reducer and machine. Frame, stirring shaft, shaft seal and other components. The specific steps and methods are as follows
Imitate Song Dynasty. According to the process conditions, mixing purpose and requirements, select the agitator type. When selecting the agitator type, you should fully grasp the dynamic characteristics of the agitator and the flow state generated by the agitator during the mixing process. Causal relationship with various mixing purposes.
Imitation of the Song Dynasty
Imitation of the Song Dynasty. According to the determined stirrer type and the flow state produced by the stirrer during the stirring process, as well as the process control requirements for stirring and mixing time, sedimentation speed, and dispersion, through experimental means and Computer simulation design is used to determine the motor power, stirring speed, and stirrer diameter.
Imitate the Song Dynasty
Imitate the Song Dynasty. According to the motor power, stirring speed and process conditions, select the reducer model from the reducer selection table. If the reducer is selected based on the actual working torque, the actual working torque should be less than the allowable torque of the reducer.
Imitation of the Song Dynasty
Imitation of the Song Dynasty. According to the output shaft head of the reducer and the support mode of the stirring shaft system, select the frame and coupling of the same model and specifications
Imitation of the Song Dynasty
Imitation of the Song Dynasty. According to the frame Select the shaft seal type based on the size of the mixing shaft head, installation accommodation space, working pressure, and working temperature
Imitation Song Dynasty
Imitation Song Dynasty. According to the installation form and structural requirements, design and select the structure type of the mixing shaft, and check its strength and stiffness .
Imitation of Song Dynasty > Imitation Song. According to the nominal center size of the frame, the shaft type and pressure level of the mixing shaft, choose to install the bottom cover, flange base or flange flange
Imitation Song
Imitation Song. According to the support and anti-vibration Conditions to determine whether to configure auxiliary supports.
Imitation Song
Imitation Song In the above selection process, the combination and configuration of the mixing device can be referred to (schematic diagram of the mixing device design selection process). During the configuration process, the key dimensions for the connection between the components are the size of the shaft head, the size of the shaft In principle, components with the same head size can be interchanged and combined.
Imitation Song
Imitation contact number Mr. Liu
Imitation