Ruian Electronics RBT-1060/C type combustible gas leak detector

Product Overview
The / type gas detector is a three-wire standard signal that can be directly connected to the combustible gas detector of the / system.

The / type gas detector is a flameproof industrial combustible gas safety detection instrument. It can be installed in indoor and outdoor hazardous locations. It plays the role of on-site monitoring. If there is a leak of flammable gas at the monitoring location, the gas detector will immediately transmit the concentration data of the leaked flammable and explosive gas to the gas alarm controller. Perform data processing. The national standard this product is designed to comply with is B.

Product qualification certificate: : Quality management system standard, fire protection product type approval certificate, inspection report, manufacturing measuring instrument license, explosion-proof certificate.




Main features
◆ Three-wire working mode
◆ Using advanced imported catalytic combustion sensor, stable performance and high sensitivity , good resistance to poisoning
◆ Using microcontroller digital processing, good stability, strong anti-interference ability
◆ Reverse polarity protection
◆ Energy saving and low power consumption
◆ Output three-wire standard signal, can be connected to or wait for the data acquisition system
◆ Can output a set of relay contact signals
◆ Explosion-proof and explosion-proof, can be used in Class I and II hazardous locations under factory conditions
◆ The entire detector The shell is made of die-cast aluminum, small and lightweight




Technical parameters
◆Detection principle: catalytic combustion type
◆Detection method: Free diffusion
◆ Detection gas: combustible gas
◆ Working voltage:
◆ Power consumption
◆ Accuracy %
◆ Signal output: ~Signal output/group Relay output
◆ Supporting controller: type gas alarm controller, / system
◆ Explosion-proof level:
◆ Protection level:
◆ Electrical interface〃internal thread
◆ Installation method: wall pipe installation




Product installation
◆ Main material: die-cast aluminum
◆ Dust cover Material: Stainless steel dust-proof net
◆ Weight:
◆ Installation method: fixed bracket tube wall installation
◆ Gas detectors should be installed in places where gas is prone to leakage, and the specific location should be based on the gas being detected Determined by the specific gravity relative to air.
When the specific gravity of the gas to be detected is greater than the specific gravity of air, the gas detector should be installed at a distance (~) from the ground, with the sensor part facing downwards.
When the specific gravity of the gas to be detected is less than the specific gravity of air, the gas detector should be installed at a distance (~) from the ceiling, with the sensor part facing downwards.
◆ Detection range: square.
◆ In order to use the gas detector correctly and prevent the occurrence of gas detector failure, please do not install it in the following locations:
Places directly affected by steam and oil fumes
Air supply vents, ventilation fans, door and other air flow Large places
Places with a lot of water vapor and water droplets (relative humidity %R
Places with temperatures below ℃ or above ℃
Places with strong electromagnetic fields.