Hunan feces dehydrator, Changsha poultry and livestock manure solid-liquid separator

Hunan Manure Dehydrator, Changsha Livestock Manure Solid-Liquid Separator) Livestock Manure Processor
) Instructions for use
) ) ) Installation
) ) The height of the host machine is customized according to the chapter to discharge dry It is advisable to facilitate the transportation of materials and sewage. Use fixed pipes as much as possible to avoid right-angle elbows that reduce flow assistance and ensure smooth flow.
) ) The incoming wires, main unit, and submersible pump connection wires are all installed on the connecting posts of the distribution box.
) ) Test run
) ) Before the test run, first add the reducer, connect the power supply to the main motor, determine the running direction of the screw shaft, stop the machine, and then lift the adjusting lever to the highest position (open the discharge port) ), twist the waste newspapers or cotton wool into a ball to block the discharge port, return the adjusting rod, install the balance block and press it with your hands. Start the pump first, then turn on the machine. After the raw waste water stops flowing out from the discharge port, slowly let go, the adjusting rod will rise again, the discharge flap will automatically open, the solid matter will be squeezed out, and the blocked matter will be removed, and the solid matter will come out. Keep squeezing out.
) ) Cleaning
) ) If you find that there is little liquid flowing out of the liquid outlet, you can perform several reverse and reverse opening actions. If there is no effect, it means that the screen needs to be cleaned. Generally, it needs to be cleaned once a day. Steps
)): Stop the pump and let the screw shaft of the main machine rotate independently. When the solid is stopped extruding from the discharging and turning point
)), open the cleaning ports on both sides of the main machine barrel and rinse with high-pressure water.
) ) If there are any debris that are difficult to clean, you can remove the screen inside and clean the screen
) ) , reassemble it, and operate it according to the test requirements, and then run it.
) ) Control circuit
) ) This control box is a special control device. It is easy to troubleshoot and the wiring is simple and easy to understand. The control system can work normally after connecting the power supply, motor and control system.
) ) Other ways to transport raw materials
) ) If you use a spiral auger or a conveyor belt to transport raw materials directly, add some clean water to the raw materials after an average of minutes of use, which can effectively Clean the sticky substances on the mesh screen and the equipment can be used normally.