1100 glazed tile press machine widened glazed tile glazed tile machine glazed tile forming machine

Glazed tile press
1. Type deflected arc glazed tile press
, equipment installation dimensions
, total equipment weight about
, number of forming passes
, processing Material width
, feeding thickness
, electronic control system, industrial computer frequency conversion control
, host power, hydraulic shearing power
, working speed/
, Hydraulic station pressure
, Glazed tile press
2. Debugging of the tile press
First, move the four corners of the front and back rows of the color steel tile press equipment from the main frame to the bottom axis The height of the upper end should be the same, and then find a line to straighten it from the first row to the last row. Check whether the lower axis is in a straight line, and adjust the left and right sides of the lower axis to be horizontal.
Find the center of the first and last rows of the color steel tile press equipment, then tighten the lock nuts on both sides, draw a straight line front and back at the center of the middle wheel, and tighten the upper and lower shafts. After the gap is adjusted, the machine can be adjusted along the straight line.
. The debugging method of the deviation of the pressure plate of the color steel tile press equipment, such as the plate runs to the right, pads the left corner (feeding rack), or falls flat on the right side (which axis is deflected and which axis is dropped) The bottom is flat, and the upper shaft falls with the bottom shaft.