955 glazed tile press machine glazed tile machine Tubotou glazed tile press machine

Type glazed tile machine
1. Type glazed tile press
, equipment installation dimensions
, feed plate thickness
, feed width
, Effective board width
, motor power, hydraulic shearing power
, depth pitch
, the entire electronic control system adopts industrial computer control (Delta)
, working speed/< br/>. The material of the roll of the tile press is steel plated with hard chromium. The hardness is
. The weight of the equipment is about tons
2. Preparation and installation method of the tile press. Before using the tile press equipment, check all Whether the connections are secure, whether the mounting bolts and nuts are tightened, and enough lubricating oil should be added to the left and right chassis before the machine can be powered on and started for test run
First, run the machine empty and observe carefully to see if there is any vibration, noise, and whether oil comes from the oil window. Whether the movement of the components is coordinated?
The mold can be installed only after everything is normal. When installing the mold, the power must be cut off, the motor belt or large gear must be moved manually, the steel profile machine can index the workbench, and raise the slide to the highest point. , it is best to use an object to support between the workbench and the bottom surface of the sliding seat to prevent the sliding seat from falling naturally and causing an accident
The mold used in this machine requires one upper mold and six lower molds of the same size. Install them first. The upper mold and a lower mold are installed directly on the hexagonal runner workbench. The upper mold is installed on the bottom of the slide, and a pad of appropriate thickness is placed to ensure that after the upper and lower molds are closed, the surrounding gaps are even. The distance between them is equal to the thickness of the required tile blank
Take the upper mold as the standard, rotate the workbench, and install the remaining five sets of lower molds. Only after the upper and lower molds are installed can the car be driven for tile pressing