Color steel tile electric shearing machine driven shearing machine parameters Electric shearing machine manufacturer

Electric shearing machinebr/> 1. Introduction to electric shearing machine parameters
Overall dimensions
Machine weight in kilograms
Shearing length
Shearing thickness
2. Shearing The method of maintenance of board machine
is to operate in strict accordance with the operating procedures.
. Add lubricating oil regularly, at fixed points and quantitatively according to the requirements of the lubrication chart before starting the machine. The oil should be clean and free of precipitation.
The machine tool must be kept clean at all times and the unpainted parts must be kept with anti-rust grease.
The lubricating oil in the motor bearings should be replaced and refilled regularly, and the electrical parts should be checked regularly to see if they are working normally, safely and reliably.
Regularly check whether the V-belt, handle, knobs, and buttons are damaged. If they are seriously worn, they should be replaced in time, and spare parts should be reported for replenishment.
Regularly check and repair switches, insurances, and handles to ensure they work reliably.
1. Minutes before get off work every day, lubricate and scrub the machine tools.
It is strictly forbidden for non-designated personnel to operate the equipment. Normally, the machine must be stopped when the person leaves the machine.
How to use the electric shearing machine: During the use of the electric shearing machine, the following situations may occur. Start the electric shearing machine and run it for several cycles to ensure that under normal circumstances, try to shear sheets of different thicknesses, from thin to thin. Extremely thick. Make sure the user is familiar with the shearing machine performance. Different blade gaps must be adjusted for different plate thicknesses during trial shearing. If the corresponding blade gap is not adjusted, the durability of the blade will be affected. During the shearing process, turn on the pressure gauge switch and observe the oil line pressure value. The pressure should be less than The pressure of this remote pressure regulating valve is set at the factory. The user must abide by this regulation and shall not increase the pressure for shearing materials that exceed the specified surface, causing damage to the machine.br/>