Supply dust removal and water-cooled universal pulverizer, stainless steel water-cooled dust removal pulverizer price

Working Principle
The water-cooled all-purpose crusher (movable hammer crusher) uses a small movable hammer to rotate at high speed and use centrifugal force to beat, so that the crushed materials are crushed through the combined effects of mutual impact and friction between the hammer head and the edge gear. Crush. This machine has a simple and sturdy structure, stable operation and good crushing effect. The crushed materials can be directly discharged from the grinding chamber of the main machine. The particle size can be obtained by replacing mesh screens with different apertures. In addition, the machine is made of all stainless steel. The inner walls of the machine casing are all machined to achieve a smooth surface, which changes the phenomenon of rough inner walls and powder accumulation in previous models, making the production of medicines, food, chemicals, etc. more in line with national standards and meeting the requirements of the country.
This machine is equipped with a screen, which can be replaced according to customer requirements. When the material is crushed to less than the diameter of the screen hole, the powder comes out of the screen and falls into the collecting barrel below, where it floats. The dust is sucked into the dust bag in the dust box through the action of the dust removal motor and filtered, and the air is discharged outdoors by the fan.
Introduction to the water-cooling device of the universal pulverizer
The universal pulverizer can be equipped with a water-cooling device according to the user's special requirements and the special physical and chemical properties of the materials to be crushed. If the material to be crushed has a low melting point, low ignition point, and is easily softened and sticky when heated, resulting in reduced crushing effect or failure to crush, or even burning or explosion, it is necessary to install a water-cooling cooling device on the crushing equipment.
A commonly used water cooling device is to install a sealed water clamp on the front and rear walls of the crushing chamber, so that flowing tap water or well water can continuously flow into the rear wall water clamp and then into the front wall water clamp. , and then flows back into the rear wall through the water clamp on the front wall, and flows out from the water outlet on the rear wall. The purpose of the water cooling device is to reduce the temperature of the crushing chamber
Technical parameters
Model+
Production capacity/
Grinding fineness (replace the screen to adjust the powder fineness)
Voltage
Motor power.+
Weight
Material bucket size*
Powder box size** (length*width*height)
Overall dimensions** (length* Width*Height)