Alcohol oil stove core energy-saving stove core environmentally friendly oil stove core HB85

One model and variety
Split burner:
One-piece burner:
Vaporization burner:
Industrial burner: (Large factory canteen, school canteen, government agency, military canteen Can be used in halls, etc.)
Remarks: The above models of stoves can be equipped with electronic igniters or infrared igniters according to requirements

Two advanced structures
Gaowang stoves have experienced countless After repeated tests and improvements, it has reliable performance, safety and practicality.
Three rows of air inlets of different sizes and angles allow the wind to rotate strongly and fully burn the fuel. The burner head is cylindrical and upward without scattering, stable and without splashing.
Secondary air inlets and wind curtains. The secondary air inlet blows secondary air to the upper fire to make the fuel burn more fully. The furnace temperature is ~℃ higher than that of the ordinary furnace. The secondary air is also a circular air curtain, making the fire cylindrical and stable upward.
Corrosion-resistant copper grease nipple. Gaowang burner uses a corrosion-resistant copper oil nozzle, so the fire is stable and does not fluctuate.

Three installations
Smooth. Install the burner smoothly on the air duct so that the upper end of the air duct is against the plane of the burner air outlet and the burner is stable and not tilted.
The top of the stove is one centimeter away from the bottom of the pot.
The position of the oil nozzle has been adjusted and fixed at the factory. Do not change it during installation.

Four Precautions for Use
It is recommended that each burner be equipped with a separate fan to ensure sufficient air volume.
Methanol fuel must have sufficient purity. When it is less than %, the combustion efficiency will be reduced.
The combustion should not contain impurities that hinder combustion, so as not to produce solidified matter during the combustion process and block the oil nozzle and air outlet.
The amount of ignition oil is moderate. Do not add too much oil to each ignition, as oil cannot leak from the air holes into the air duct, causing the air duct to catch fire and cause danger.
Equipped with oil quantity switch. Each burner is equipped with a separate oil quantity switch. When a burner is out of service, turn off the sub-switch. It is equipped with a main oil supply switch. When each burner is out of use, turn off the main switch and all switches.

Five maintenance
Clean the furnace. If sediment is found blocking the air holes or oil nozzles in the burner, it is advisable to use a steel needle to clear them once a week. For stoves using electronic ignition, this will depend on the situation.
Clean the oil nozzle. There are deposits in the inner hole of the oil nozzle that will affect combustion and must be cleaned in time. The way to clear the oil nozzle is to loosen the oil nozzle, insert a steel needle into the oil nozzle, and remove the sediment.