Recording pen special chip capacitor 400V 824 X7R 1812 package

电压：

400V

容量：

820NF

尺寸：

4.6*3.2

According to the structure, it is divided into three categories: fixed capacitors, variable capacitors and trimmer capacitors. According to the electrolyte, they are: organic dielectric capacitors, inorganic dielectric capacitors, electrolytic capacitors and air dielectric capacitors, etc.. According to the use, they are: high frequency bypass, according to the structure. Divided into three categories: fixed capacitors, variable capacitors and trimmer capacitors
According to the electrolyte classification: organic dielectric capacitors, inorganic dielectric capacitors, electrolytic capacitors and air dielectric capacitors, etc.
According to the use: high Contact Ouyang at Frequency: Free sample sending service is available. Your call bypass, low frequency bypass, filtering, tuning, high frequency coupling, low frequency coupling, small capacitor
are always welcome. Frequency bypass: ceramic capacitor, mica Capacitors, glass film capacitors, polyester capacitors, glass glaze capacitors
When starting to solder all the pins, you should add solder to the tip of the soldering iron, and coat all the pins with flux to keep the pins moist. Touch the tip of the soldering iron to the end of each pin of the chip until you see the solder flowing into the pin. When welding, keep the tip of the soldering iron parallel to the pin being soldered to avoid overlapping due to excessive soldering. Contact Ouyang: Free sample delivery service is available, your call is always welcome
??? After soldering all the pins, soak all the pins with flux to clean the solder. Wipe away any remaining solder where needed to eliminate any shorts and overlaps. Finally, use tweezers to check whether there is any weak soldering. After the inspection is completed, remove the flux from the circuit board, dip a hard-bristle brush in alcohol and scrub carefully along the direction of the pins until the flux is gone.