Shandong potato flour machine manufacturer

发货方式：

物流

包装：

木箱

价格：

电议

Sales: , Sales Manager: Ms. Liang Sales: Address: Xingwan Industrial Park, Hebei Province
Product Introduction:
Shandong Potato Flour Machine Manufacturer The potato flour machine is driven by a sheave drive to transport and squeeze the auger. Put the dough that is soft and hard into the dough and squeeze it out through the holes of the molding die to form noodles. At the same time, the noodles are dropped into the boiling pot.
Product use
Technical parameters
Equipped with power: ./.
Spindle speed: r
Production efficiency: /
Machine weight:
Dimensions:&
Product operation:
. Connect the power supply and test run: first remove the template and V-belt, then connect the power and move it. After confirming the direction of the motor (marked by the arrow), install the V-belt and Close and try turning for one minute before installing the template. If the steering is reversed, there is a risk of damaging the template.
.Machine inspection: Before starting the machine, you must check whether the machine parts are normal, whether the screws are loose, and the grounding wire must be installed.
.Modify the machine head:
.Disassemble the template: First pay attention to the direction of rotation, which should be the same as the direction of the groove wheel. Twist it hard. If it cannot be twisted by hand, you can use a wrench to pull it.
.Remove the guard cover: First loosen the screws, open the cover by hand, and tighten the triangle belt.
.Noodle making: Mix the standard flour with cold water to make a dough similar to that of knife-cut noodles and hand-pulled noodles. Knead it with your hands, cut it into appropriate small pieces, roll it in dry flour and set aside (other edible flour, Multigrain noodles are also available). If the kneading fails, the dough will become sticky, the auger will become sticky, and the noodles will stick to the teeth.
. Feeding operation: Start the machine and test it for one minute, then you can feed and press the noodles. Put the mixed noodles for use into the feeding port one after another. The noodles extruded by the auger are directly pressed into the boiling pot. , after pressing, use a spatula to remove the remaining noodles from the bottom of the template. The adhering noodles should be separated in time with boiling water and stir.
. Washing and cleaning: Remove the template and remove the auger. After cleaning, please restore and install according to the disassembly sequence.