FU chain conveyor delivers smoothly and sincerely sells Tianrun chain conveyor

Before installing the chain conveyor drive device, you must first turn on the power, check whether the rotation direction is correct, cut off the power, adjust the position of the drive device, ensure the center position of the large and small sprockets, adjust the fixed sprocket cover, and tighten all anchor bolts . After the machine is installed, it is necessary to conduct a no-load test run. Before the test run, the debris in the machine tank should be cleaned, add enough lubricating oil to each lubricating part, turn on the power, and start the no-load test run for 1 minute. During operation, observe whether the running direction is in accordance with the regulations. The direction is consistent, the entry wheel is meshed correctly, there should be no chain jamming or chain skipping, the operation must be smooth, no deviation, no jamming is allowed, the driving device is noiseless, and the no-load power must not exceed % of the rated power. After the no-load test run, tighten all bolts.
After the chain conveyor is tested for an hour without load, it is then tested with load. Before the test, it is first checked whether the material meets the usage requirements, and then it is started without load. After the operation is normal, the material is gradually added to reach the material level specified by the design. height, the feeding should be uniform and continuous, and no sudden feeding is allowed to prevent blockage or overloading. The feeding port should be equipped with a grating to prevent large pieces of materials and miscellaneous parts from mixing into the machine slot. During the test run, the load power, linear speed and conveying capacity of the conveyor chain should be checked, and whether they are consistent with the actual situation. After the load test run is an hour, it can be stopped. Feeding should be stopped before trial operation and shutdown, and the machine can be shut down only after the materials are unloaded.
The chain conveyor must be started without load and stopped without load. When using it, a dedicated person should be assigned to check the working status of each machine part regularly every day and whether the connecting parts are loose. If any problems are found, they must be dealt with in time.
Phone
Cell phone