Year1
- 随机油箱：
- 内置
- 冷却系统：
- 水冷式
- 启动系统：
- 手柄
Product description
QQ screenshots
QQ screenshots
Some model parameters are as follows
MH Yamaha.H horsepower
Model: MH
Horsepower: Horsepower
Engine type: two-stroke single cylinder
Full width (mm mm)
Stern plate height (mm mm)
Propeller maximum output power corresponding to speed (r/m):./
Maximum fuel consumption//H
Random fuel tank: built-in
Cooling system: water-cooled
Starting system: handle
Oil supply: pre- Mixed propeller pitch: aluminum
Displacement volume (m)
Weight
Volume cube:.
MH Yamaha.H Horsepower
Model: H< br/>Horsepower: Horsepower
Engine type: two-stroke single cylinder
Stern plate height (mm mm)
Propeller maximum output power corresponding speed (r/m):./
Maximum fuel consumption//H
Built-in random oil tank
Cooling system: water-cooled
Starting system: handle
Oil supply: premixed
Propeller pitch: aluminum
Displacement (m)
Weight:.
Volume cube:.
MH Yamaha.H Horsepower
Model: MH
Horsepower:.Horsepower
Engine type: two-stroke
Cylinder
Stern plate height (mm mm)
Propeller maximum output power corresponding speed (r/m):.(.)
Maximum fuel consumption//H
Random fuel tank
Cooling system: water-cooled
Starting system: handle
Oil supply: premixed
Propeller pitch: aluminum
Exhaust volume (m)
Weight
Volume cubed:.
MH Yamaha H Horsepower
Model: H
Horsepower: Horsepower
Engine type: Two-stroke cylinder
Height of stern plate (mm mm)
Maximum output power of propeller corresponding to rotation speed (r/m):/
Maximum fuel consumption//H
Random fuel tank
Cooling system: water-cooled
Start system: handle
Oil supply: premixed
Propeller pitch: aluminum
Displacement volume (m)
Weight
Volume 6
MH Yamaha H Horsepower
Model: HMH
Horsepower: Horsepower
Engine type: Two-stroke cylinder
Stern plate height (mm mm)
The maximum output power of the propeller corresponds to the rotation speed ( r/m):./
Maximum fuel consumption//H
Random fuel tank
Cooling system: water-cooled
Starting system: handle
Oil supply: premixed
Propeller pitch: aluminum
Displacement (m)
Weight
Volume cube:.
Outboard motor: also known as stern motor, outboard motor, as the name suggests, the engine is on the side of the ship It is suspended above the tailboard, with the engine at the top. The engine crankshaft is connected to the vertical shaft, and then the horizontal shaft is finally output to the propeller. When this kind of machine turns, the entire engine swings left and right with the steering device, because the propeller directly follows the driving device. The steering is extremely flexible, the whole machine is simple to install and easy to carry. It is widely used in small yachts, inflatable power boats, assault boats and various fishing boats.
MH (Yamaha) two-stroke outboard motor, motor, engine, Japanese Yamaha (mh) marine engine has the characteristics of stable performance, strong horsepower, low fuel consumption, less pollution, etc. The excellent anti-rust and anti-corrosion system can increase the ship's The durability of the outer engine is recognized among current marine engine brands.
After-sales service and commitment: The Yamaha boat motors sold by our company are all shipped from MH China warehouse. Guaranteed authenticity and quality, one-month warranty!!! Lifetime maintenance service!!!
Brief description
1: Reminder, the following operating methods are strictly prohibited
. Disassemble the host by yourself for the purpose of exploration It is easy to cause damage to important components.
. Hitting rocks or running aground can easily cause damage to the main engine. Operating in poor water quality can easily cause cooling water system failure.
. The maximum throttle is continuously operated for more than 10 minutes and the two-stroke machine does not mix with two-stroke oil, which can easily cause piston and cylinder burning.
.Changing gears at high speed and suddenly slamming the accelerator pedal can easily cause the piston crankshaft and transmission gear to break.
Precautions for use of outboard motors
Two: Handling of fuel and lubricating oil
: Four-stroke fifth-quarter lubricating oil is divided into two parts. Add stroke gasoline engine oil to the upper engine oil tank, and add stroke gasoline oil to the lower gear. Fill the oil tank with gear oil.
: Two-stroke outboard motor lubricating oil is divided into two parts. Two-stroke lubricating oil is added to the fuel (gasoline), and gear oil is added to the lower gear oil tank.
: The mixed oil ratio of the two-stroke outboard motor is: The fuel mixing ratio within the running-in period is: or:, and the fuel mixing ratio after the running-in period is: or:
: Antifreeze gasoline engine lubrication is used in northern areas in winter oil and gear oil. Outboard motor running-in period: The running-in period should be at least an hour. After the running-in period, the lubricating oil should be replaced once. : Throttle control should not exceed % within hours during the running-in period, and should not exceed % within hours
Three: Starting and stalling the outboard motor
: The fuel tank should be filled with enough fuel when starting for the first time, and the external fuel tank should be connected Connect the oil pipe (the hand oil pump cannot be connected backwards) and pump enough fuel.
: The clutch is in the disengaged or neutral position, close the choke or switch to % position, set the throttle to %, and quickly pull the starter cord. If it cannot start normally, after a few minutes of inactivity, quickly pull the starter cord until it starts.
: The method of flameout is to gradually reduce the throttle to the minimum position and press the flameout button to achieve flameout. Do not press the flameout button when running at high speed, as this is not conducive to restarting the machine.
Four: Prohibited operating methods should be strictly observed for outboard motors
: It is advisable to put the propeller of a water-cooled machine into the water for at least one centimeter. It is prohibited to test the machine without water or in a small water tank with a volume of less than cubic meters. machine, otherwise it will cause the water pump impeller to burn out due to instantaneous water shortage.
: The machine is prohibited from starting without lubricating oil.
: It is forbidden to suddenly slam the accelerator of the machine, and it is forbidden to change gears at high speed, otherwise the piston crankshaft and the transmission gear may break.
: The maximum continuous operation time of the throttle should not exceed minutes, otherwise it will cause piston and cylinder burning.
: It is forbidden to start operation in weedy shoals. Melting reefs and strandings can easily cause damage to the main engine gear. Poor water quality can easily cause cooling water system failure.
These contents may be helpful to you: If the propeller of your MH two-stroke outboard hits a hard object during use, the safety pin will break to protect the engine from damage. The performance is as follows: the engine starts. , but the propeller does not rotate and there is no power output. At this time, you need to stop the machine and replace the safety pin. In addition, the flameout key must be inserted into the flameout switch before the machine can start. Many customers have spent a long time trying to start and cannot start and call for consultation. This is the reason why the engine stalls. The other end of the key should be hung on the operator's wrist or clothes. If the operator falls into the water, he will pull out the flameout key from the flameout switch and the engine will stall, which plays a protective role. The very user-friendly design also has the added fuel tank. The oil must be a mixture of gasoline and two-stroke engine oil evenly mixed in proportion. These are described in detail in the instruction manual, so if you buy an outboard motor, please read the instruction manual carefully first. (Note: The machine must be started in the water, and the water level must be about one centimeter below the pressure plate on the propeller. This is because the machine is water-cooled and has a water pump. The water pump impeller is made of rubber material. If it is started on land, there will be no water lubrication and heat dissipation. , the water pump impeller will wear out quickly, resulting in insufficient cooling water circulation, machine overheating and other failures.)
Yamaha two-stroke outboard motor, one box contains two machines and each is packed in plastic foam, and the entire package volume is approximately:. Cube, when we ship a machine to an out-of-town customer, we will repackage it outside the foam. The machine’s random accessories include: a Chinese/English manual, a spare starting pull cord, a spare spark plug, and a spare tool bag (above) In the random plastic bag), one flameout key, two spare safety pins, and two spare propeller cotter pins (the above are on the machine control handle).
Jiangsu Youlong Rescue Equipment Co., Ltd. provides you with MH Yamaha outboard motors, two-stroke/four-stroke, motors, engines, and propeller products. After you successfully place an order, it means that you have become a respected customer of Youlong Rescue. !
Friendly reminder from Youlong Rescue: Within two days after you receive the goods!
It was found that the product MH Yamaha outboard, two-stroke/four-stroke, motor, engine, and propeller had obvious manufacturing defects.
If the goods have been exchanged but still have quality problems, you can request a return!
When the customer receives the goods, he unpacks and inspects them in front of the deliveryman. If he finds that the goods have quality problems, he can ask for an exchange!
Contact person: Miss Wang
Contact information
WhatsApp
