Huaxing reducer installation method

Reducer
With its small size, wide deceleration range, high precision and many other advantages, it is used in servo, stepper, DC and other transmission systems. Its function is to ensure precision transmission and is mainly used to reduce the speed, increase the torque and reduce the load/motor inertia ratio. In the past few years, some users have broken the output shaft of the reducer due to illegal installation and other human factors when using the reducer, causing the company to suffer unnecessary losses. Therefore, in order to better help users make good use of the reducer, we will introduce to you in detail how to install the reducer correctly.
Correct installation and use of reducer are important links to ensure the normal operation of mechanical equipment. Therefore, when installing the reducer, be sure to strictly follow the installation and use-related matters below and assemble and use it carefully.
Step 1
Before installation, confirm whether the motor and reducer are intact, and strictly check whether the dimensions of the parts connecting the motor and the reducer match. Here are the positioning boss, input shaft and reducer of the motor. Machine grooves and other dimensions and fit tolerances.
Step 2
Unscrew the screw on the dust-proof hole on the outside of the reducer flange, adjust the system clamping ring to align the side hole with the dust-proof hole, insert the inner hexagon and tighten it. After that, remove the motor shaft key.
Step 3
Connect the motor and reducer naturally. When connecting, it must be ensured that the concentricity of the output shaft of the reducer and the input shaft of the motor is consistent, and that the outer flanges of the two are parallel. Inconsistent concentricity may cause the motor shaft to break or the reducer gear to wear. In addition, during installation, it is strictly forbidden to hit with a hammer to prevent excessive axial or radial force from damaging the bearings or gears. Be sure to tighten the mounting bolts before tightening the force bolts. Before installation, wipe the anti-rust oil on the motor input shaft, positioning boss and reducer connection parts with gasoline or zinc-sodium water. Its purpose is to ensure the tightness of the connection and the flexibility of operation, and to prevent unnecessary wear and tear.