Anyuan DYTZ straight electro-hydraulic push rod DYTP parallel electro-hydraulic push rod

Things to note when installing and using straight electro-hydraulic actuators, parallel electro-hydraulic actuators and split electro-hydraulic actuators. There should be enough space for installation of electro-hydraulic actuators, and special orders should be made for high-temperature environments.
Users can configure the limit switch according to control needs.
Before installation, the electro-hydraulic push rod should be placed flat on the ground. The oil level of the injected hydraulic oil brand and precision grade should be at the lower edge of the observation port. The oil level of the split push rod should be within the distance from the box.
The exhaust screw ring of the exhaust hole should be loosened before use.
Please try booting the computer during installation.

Integral push rod, it can be operated when connected to the power supply

Split push rod, connected to the power supply, the oil cylinder can reciprocate several times without load, so that the oil cylinder and oil pipe The air in the push rod is discharged and the load is put on it
Maintenance of the electro-hydraulic push rod
In order to ensure the service life of the high-pressure oil pipe, the oil pipe must be fixed with rubber.
Hydraulic oil must be filtered or replaced regularly, once a year or at a customized period based on actual work.
If the motor is left idle for a long time, the insulation of the motor must be checked before being put into use.
Simple Troubleshooting

It cannot operate when it is first installed. Check that the motor is not running or there is insufficient oil.

If it cannot operate after a period of use, remove the hydraulic control plug, clean the spool of the hydraulic control valve, and replace the hydraulic oil.
After being used for a long time, the push rod can be pushed and pulled without load, but cannot stand with load. Replace the seal for the upper hole of the piston in the cylinder. If the sealing surface leaks, replace the seal. If oil drips from the extension of the oil plug rod, replace the shaft seal.
The company's main products are electric push rods, electric hydraulic push rods, electro-hydraulic palate gates, electric jaw gates, electro-hydraulic corner drivers, imported material opening sizes, electro-hydraulic push rods, electro-hydraulic push rods, flat gate valves, electric push rods. Electric push rod, electro-hydraulic push rod, explosion-proof push rod, jaw gate, electro-hydraulic sector gate, belt stripping machine, wire rope stripping machine, single-side unloader, double-side unloader, wire rope core stripping machine, electric push rod, electric push rod, electro-hydraulic Push rod explosion-proof push rod jaw gate electro-hydraulic sector gate belt stripping machine wire rope stripping machine single side unloader double side unloader type broken belt catcher belt conveyor broken belt catcher belt broken protection Device broken belt catcher layered belt stripping machine belt conveyor deflector chain type one-way deflector fully automatic deflector variable groove angle unloader electro-hydraulic unloader plow unloader
Contact person Ji Xueqin
Mobile phone number
Fax
Ali Wangwang
Email@
Anyuan electro-hydraulic actuator/>