Special gear pump for paint

Paint gear pump (

Electrostatic gear pump, gear paint pump, paint pump
). The working principle of the gear pump is that two gears of the same size mesh and rotate with each other in a closely matched
shaped pump body. The outer diameter and both sides of the gear are closely matched with the pump body, and rotate along the pump body as the teeth rotate. , when the teeth mesh, the paint is output from the suction port and enters between the two gears. In order to meet various operating requirements, the paint gear pump is used with a speed-regulating motor and a frequency converter. It is suitable for all types of granular liquid paints.
,
For conveying viscous paints such as corrosive solvents, inks, and glues, the paint output can be accurately controlled according to different process needs
,
Gear pumps are used in special operating situations such as frequent changes of paints and colors. The paint pump can also be quickly and effectively cleaned for color changes

, speed

minutes, oil pump output

< br/> points, the pressure is


, pump shaft
,
top surface

teeth,
,

, pump shaft
, top surface

teeth,

.
Pump body installation holes,
(
Paint pumps and repairs can be customized according to customer requirements) Specifications
Faults and countermeasures

Gear pump does not operate
①
The electrical control part should check the wiring.
②
If the oil pump is not clean, the gear and main shaft are stuck with paint. The main body of the gear pump and the main shaft should be cleaned before installation.
③
Loosen and tighten the couplings of the motor and oil pump.

Cannot pump paint
①
The oil seal is broken. If there is no seal, turn the spindle and replace the oil seal.
②
If the oil pipe at the joint is worn, the bad part should be cut off and the oil pipe should be reconnected.
③
If the oil pipe is clogged, it depends on the severity of the situation. If it is light, blow it with air and if it is serious, replace the oil pipe.
④
The oil outlet of the atomizer is blocked. Clean the paint at the oil outlet.
⑤
The oil pump is worn and should be returned to the company for repair or scrapped.
Vertical multi-stage centrifugal pump/
The original text is reproduced from Asia Fluid Network. Please indicate the source for reprinting