Detailed introduction of thorn line

The burr wires produced by our company are two sets of electrostatic precipitator cathode wire rolling production lines (integral awn, split awn) and number of punches. The large lathe table accessories include star wires, imported stainless steel spiral wires, and cross burr wires. , type awning needle, bone spur awning needle, straight four-tooth awning needle, straight two-tooth awning needle, oblique four-tooth awning needle, awning thread connector (round hole awning thread spiral rod joint and awning thread Barbed wire connectors (elliptical holes), etc. There are many types of corona electrodes. The more sharp discharge corners, the better the corona effect. However, the more sharp discharge corners, the more difficult it is to make and install. Corona wire electrodes are generally connected High-voltage electricity requires good insulation devices. The spacing between corona wires should be appropriate. Too far apart will affect the corona current. Too close a spacing between corona wires may cause screen defects, which will weaken the electric field intensity on the surface of the corona wires. The upper and lower parts of the dust collecting pole are fixed, and the dust collecting poles are grounded. Generally, it is required that dust is easy to settle on the pole plate, and the secondary dust generated after rapping is small. At the same time, the pole plate is required to be lighter and lighter. It must have a certain stiffness and the dust will settle easily without deformation during rapping.
Our company also produces anode plate (,,,,, type) type burring wire, type stainless steel burring wire, type burring wire , eight-barbed barbed wire, zigzag wire, fishbone needle wire, wire, angle steel barbed wire, wire rope barbed wire, star wire and other cathode wires, various components of the cathode and anode rapping parts, electrical appliances, insulation and other components
Mobile contact: Manager Yang
Welcome to call