Factory direct sales electromagnetic pulse valve | pulse valve--Nokind

When installing the electromagnetic pulse valve, please pay attention to the following matters:
The best way to install the solenoid valve is vertically to the horizontal pipe, with the coil upward. [Prohibited word] tilting is allowed when conditions do not permit it. Otherwise, normal use cannot be guaranteed.
. The parameters on the solenoid valve nameplate should be consistent with the actual usage requirements.
. The arrow on the solenoid valve body should be consistent with the flow direction of the medium.
. To ensure the normal use of the electromagnetic pulse valve, please install an oil-water separator in front of the solenoid valve.
In dangerous environments, in order to prevent accidents such as explosions caused by sparks, explosion-proof solenoid valves should be used.
Please thoroughly purge the air bag and pipeline before installation to avoid foreign matter damaging the diaphragm and causing solenoid valve failure.
When the solenoid valve fails, in order to isolate it in time and facilitate maintenance, it is recommended to install a bypass (bypass) device.
When the electromagnetic pulse valve is not installed temporarily, it can be stored indoors at ~℃, relative humidity, but without corrosive gases. Avoid open-air storage as much as possible.
Contact person: Li Ying
Contact number:

>
Fax:


Corporate website:
<:..c
Company email:
@.c
Mobile phone:

:

(
You can remember me
. If the price is right, you can contact me at any time.
I am online every day)