HY type waterproof treasure

This product is a gray one-component powdery material, which is a cement-based inorganic rigid waterproof material. The retarded setting time is about

minutes
. It can be widely used for waterproofing treatment in basements, underground garages, toilets, swimming pools, storage pools, kitchens, walls, floors, underground tunnels, etc.
Product Features
Non-toxic, odorless, non-flammable, and does not pollute the environment.
Easy to use, just add water and stir.
The construction is simple, fast and safe. It can be constructed directly on the water surface and on the wet base surface, which can shorten the construction period and reduce the cost.
It has a wide range of applications and can be used for moisture-proof treatment of large areas of wet surfaces without clear water. It can also be used for water-carrying operations on seepage surfaces and leaks to quickly plug leaks.
Contains special active agents that can penetrate into the matrix to form a permeable waterproof layer.
Excellent bonding performance, it can be combined with various materials such as masonry, concrete, cement mortar, etc., so that the matrix and waterproof layer can be combined into a solid whole, improving the resistance to penetration pressure.
High temperature resistance (
℃), low temperature resistance (
℃), aging resistance and corrosion resistance.
Instructions for use
For base layer treatment, first remove the attached dust, grease, loose matter, etc. on the surface of the base layer to make the base layer clean, solid, free of powdering, hollowing, etc., and sprinkle water to moisten it (saturated with water but no obvious Water) The base layer whose surface is too smooth should be appropriately roughened to increase the bonding force between the base layer and the waterproof layer.
Construction method: Mix this product and water according to

ratio to form a mud paste, let it stand for
minutes, stir evenly, and use a scraper to scrape the base surface where the waterproof layer is to be made. Use a board or spatula to scrape (wipe) the static slurry
thick, and compact it until the first layer becomes hard (no mark when pressed by hand). Scrape (wipe) the second layer to a thickness of about

, the surface can be polished with a brush or a brush, or you can use a brush or a brush to apply a layer of slurry after the second layer has hardened (the grey-water ratio is approximately

and then sprinkle with water for curing
More than days are enough.