HY type waterproof treasure

This product is a gray one-component powdery material, which is a cement-based inorganic rigid waterproof material. The retarded setting time is about
minutes
. It can be widely used for waterproofing treatment in basements, underground garages, toilets, swimming pools, storage pools, kitchens, walls, floors, underground tunnels, etc.
Product Features
Non-toxic, odorless, non-flammable, and does not pollute the environment.
Easy to use, just add water and stir.
The construction is simple, fast and safe. It can be constructed directly on the water surface and on the wet base surface, which can shorten the construction period and reduce the cost.
It has a wide range of applications and can be used for moisture-proof treatment of large areas of wet surfaces without clear water. It can also be used for water-carrying operations on seepage surfaces and leaks to quickly plug leaks.
Contains special active agents that can penetrate into the matrix to form a permeable waterproof layer.
Excellent bonding performance, it can be combined with various materials such as masonry, concrete, cement mortar, etc., so that the matrix and waterproof layer can be combined into a solid whole, improving the resistance to penetration pressure.
High temperature resistance
℃ low temperature resistance
℃ aging resistance and corrosion resistance.
Instructions for use
For base layer treatment, first remove the dust, grease, loose matter, etc. attached to the surface of the base layer to make the base layer clean, solid, free of powdering, hollowing, etc., and sprinkle water to moisten and saturated the surface, but no open water will appear. Base layers with too smooth surfaces should be roughened appropriately to increase the adhesion between the base layer and the waterproof layer.
Construction method: Mix this product and water according to
proportions to make a paste. Leave it for
minutes and stir evenly. Use a scraper or spatula on the base surface where the waterproof layer is to be made. Scrape the static slurry
thick, and compact it until the first layer has hardness. Then scrape the second layer with your hands when there is no mark. The thickness is about
. The surface can be polished with a brush or a brush, or you can apply it on the surface. After the second layer has hardened, use a brush or a brush to apply a layer of slurry with a gray-to-water ratio of about
and then sprinkle water to cure it for
or more days.