Factory heating equipment electric heating curtain, radiant heater, electric heating plate

型号：

SRJF-6

功率：

1200W

供热面积（㎡）：

8-12㎡

Factory heating equipment, electric curtain heater, hot plate, and indoor temperature requirements. When using a heater in winter, the indoor temperature should be controlled at no less than ℃, and the average indoor temperature should reach ℃. However, it is not suitable for the elderly and children. In other words, the ℃ standard is relatively low, but it should not be too high. Too high will make people feel uncomfortable, and a large temperature difference between indoor and outdoor can easily cause colds and other diseases.
Air must be accumulated in the second discharge pipe
Due to the accumulation of air in the pipe, water circulation will stagnate and affect heating. Therefore, in addition to installing an exhaust valve on the top floor, a manual exhaust valve is installed at the end of each group of heaters. The movement should be small when inflating to prevent it from breaking. When the gas and water are mixed, the air valve should be tightened in time.
Three solutions to water leakage
If water leakage is found at the pipe connection during the heating period, no matter how big or small, you cannot handle it yourself. You must promptly notify professional maintenance personnel to decompress the leakage point before repairing it. Repairs under pressure must not be done , this will expand the leakage point and damage the pipe fittings.
Four reasons why it is not hot
If the heater is not hot as a whole, it may be because the outdoor water inlet or return water valve is not open. If a single household is not hot locally, it may be caused by the attic not venting. The radiator is half hot and half cold, which is caused by air accumulation at the rear. In short, under the condition of ensuring the circulation pressure and temperature, the main reason for the lack of heat is air blockage, which can be solved by deflating the air.
Five, you cannot modify the heating pipes by yourself
Because the pipes have a certain slope when the pipe network is installed, so that the air in the pipe can gather to the top and be exhausted in time. Unauthorized modification may cause the slope to go wrong and cause local air blockage. And if it cannot be discharged, it will not only affect yourself, but also the residents of the entire unit.
Six Decoration of Radiators
When decorating radiators, maintenance should be taken into consideration. The opening area should be such that the entire set of radiators can be disassembled and lifted out. And the decorative parts should be movable. If there is a problem with the radiator, it can be easily lifted out to expose the entire pipe and radiator. There should be room for removable valve replacement at the opening of the standpipe branch valve.