- 1:
- 1
- 1:
- 1
- 1:
- 1
北京大兴区锚栓植筋打孔
1、植筋(锚栓):
首先将工作面内的杂物清理干净,留出操作面。植筋前将植筋位置处的砼保护剔凿,露出原结构主筋,再确定植筋打孔位置,以避免损伤原结构钢筋。(植栓工程执行此套工艺要求)
a、工艺流程
现场清理——定位放线——钻孔——清孔——钢筋处理——配胶——植筋——固化养护——验收
b、操作工艺
l 现场清理:根据现场施工作业面情况,施工前甲方配合搭设脚手架操作平台,接通电源;先将图纸要求部分进行切除,并将需植筋部位的现场清理干净。
l 定位放线:植深15d(d为钢筋直径),在需植筋部位弹出钢筋植入位置线,并用红油漆明确标识。
l 钻孔:确定植筋位置后开始钻孔,采用电锤进行打孔,如植筋部位遇到原结构主筋,应作好记录并及时联系协商解决,成孔直径应大于钢筋直径4-6mm。
联系人颜先生 联系电话010-68606136 手机13681294288
Disclaimer
The information/pictures/parameters, etc. displayed on this webpage about【Anchor bolt planting and reinforcement drilling in Daxing District, Beijing】are provided by member【Beijing Shengshixin Engineering Technology Co
】,By Titker Trade Network members 【Beijing Shengshixin Engineering Technology Co
】is solely responsible for the authenticity, accuracy and legality of the information/pictures/parameters, etc.,Titker Trade Network only provides display services. For your safety, please choose Titker Trade Network for online trading, otherwise Titker Trade Network will not bear any responsibility for this.
If your legitimate rights and interests have been infringed, please contact Titker Trade Network customer service as soon as possible. We will serve you wholeheartedly. Thank you for your attention and support to Titker Trade Network!