B type flange unloader produced by Kejian Environmental Protection

>Common faults
1. During the transportation and installation process of the star unloader, it should be kept stable to avoid collisions, which may cause the shell to break and deform.
2. Before leaving the factory, the reducer of this machine has been filled with lubricating oil number grease, and the dust discharge valve has been filled with lithium-based grease. Within one month after being put into use, the transmission and bearing components should be replenished or replaced with grease. If the ambient temperature is high, humid or there is too much dust in the air, the oil change time should be shortened appropriately.
3. During use, if the equipment leaks air or ash along the axial direction, just tighten the pressing cover.
4. During operation, avoid overloading the equipment due to large material particles and strong adhesion, or equipment jamming or motor short-circuit caused by foreign matter in the dust collector, which may cause equipment or damage. It is recommended that users bolt the equipment in time. Check and install overload protection device.
5. This machine is suitable for continuous working system and allows forward and reverse operation.
6. When fitting the output shaft and input shaft of the unloader with other parts, direct or hammering is not allowed to prevent damage.