Infrared induction methanol stove alcohol-based fuel special 13903074958

Infrared electronic ignition energy-saving alcohol-based frying stove practical instructions Infrared electronic ignition alcohol-based frying stove uses alcohol (methanol) as the main raw material. Environmentally friendly, energy-saving, smoke-free and non-toxic, it complies with national environmental protection requirements and is widely used in catering in hotels, agencies, troops, schools, etc. The automatic ignition power of this stove can be freely adjusted, and the pot can be burned and extinguished when the stove is on the stove. It has an electronic sensing anti-air burn function, which solves the safety hazard of accidental leakage of fuel in the stove core. It saves fuel and is extremely convenient to use.
First installation method
Connect the fan power cord.
Connect one end of the oil pipe to the oil input end of the single frying furnace and put the other end into the oil tank.
Second-use method
Open the fuel tank ball valve to switch fuel to flow freely into the oil pipe.
The oil control switch needs to be turned to / (which is also the half position of the air valve in front of the panel to the middle.
Start the power supply, put the pot into the stove ring and ignite successfully, turn on the fan to the maximum, adjust the fire power to the required Adjust the firepower to the required firepower and use it normally. Remove the pot from the fire and turn off the fan power immediately to avoid air burning.
When you turn off the power after use, turn off the oil valve to the minimum and finally close the damper to the middle.
Turn off the oil valve switch to avoid accidental leakage of fuel.
Triple Tips
The oil tank should be installed away from fire sources, air circulation, and sunlight should not directly shine above the stove.
Add Remember to stay away from fireworks when using fuel.
After use, you should turn off the oil pipe and ball valve switch. Always check whether the oil tank pipe switch is leaking.
If there is too much oil left in the stove, the liquid level is immersed in the ignition needle. The oil valve is closed and ignited first. Opening the oil valve later will cause difficulty in ignition or failure to ignite. Use manual ignition to burn off the remaining oil in the stove core and ignite according to normal procedures.
High pressure will be generated when the stove core is ignited. Do not disassemble or do not press the button until the stove core is ignited. Accidents may occur even if the operation is changed and the purpose is changed
!
The price of an infrared single frying stove is RMB/unit. Single-tailed frying furnace unit/set
Infrared double-frying single-tailed furnace unit/set Ordinary double-frying single-tailed furnace unit/set
Infrared accessory unit/set (stove head ignition needle solenoid valve controller receiving head emission Head)
Shipping/Contact Address 1st Floor, Yayuan Industrial Zone, Jiahewanggang, Baiyun District, Guangzhou City, Guangdong Province
Jiaolonggang Seaside Tower, Section 4, Shuangnan Avenue, Shuangliu County, Chengdu City, Sichuan Province
Contact WeChat
Contact number (Guangzhou Card) (Chengdu Card)