Installation of TEDA rubber and plastic wear-resistant coal bunker lining

密度：

0.93

Coal bunker lining installation method 1. Taking into account the angle of loose materials and the friction coefficient between the material and the lining, it is recommended that the angle between the material surface of the bunker and the horizontal direction is so that after the lining is installed, the material can achieve overall flow in the entire bunker to avoid or reduce Smaller retention zones eliminate the need for oscillators and air cannons.
Before installing the second lining board, the condition of the silo should be checked. Any bulges or dents should be smoothed as much as possible. The used cement silo body should be thoroughly cleaned in advance to prevent the lining board from being installed loosely. Or a board failure may occur.
Before installing the three linings, the installation process should be formulated according to the actual situation of the silo and followed during installation.
When installing the four lining boards, the joints perpendicular to the material flow direction should be minimized to reduce the flow resistance of the material and achieve the best logistics effect.
5. Before installation, the lining board should be cut and cut. The upper and lower sides should be beveled. The joints between the boards should be overlapped and installed in an upper and lower manner, and different reservations should be made according to the local climate and the shape and size of the silo. size expansion joints.