Water tank self-cleaning sterilizer

Product Introduction
The water tank self-cleaning sterilizer uses the principle of micro-electrolysis electrochemical reaction to cause the dissolved chlorine ion water molecules in the water to produce strong oxidizing substances to achieve the purpose of purifying and disinfecting the water body, sterilizing and killing algae. effect. The equipment consists of three parts: circulation pump energy releaser, micro-electrolyzer controller and energy transmission cable. It can be divided into external type and built-in type according to the installation position.
Working Principle
Kill bacteria in drinking water by circulating micro-electrolyzed water substance chlorine dioxide
Ozone
Active oxygen
Molecular chlorine and other oxidizing substances When water stays for a long time, a certain concentration of oxidizing substances can be produced in the water, and continuous disinfection is equivalent to the effect of residual chlorine.
Installation method
Installation method of a built-in water tank self-cleaning sterilizer
Steps
Install the energy controller in a dry and ventilated place with rainproof and waterproof measures.
Connect the control cable to the energy controller
Let the water level exceed the energy release circulator, and turn on the main power supply at the designated time
The water tank self-cleaning and disinfection device will start working
Required When cleaning and maintaining the water tank pool, first cut off the main power supply of the equipment, and then turn on the power at the designated time when using it again
2. Installation method of external water tank self-cleaning sterilizer
Place the external water tank self-cleaning sterilizer in the water tank Externally, ensure that the center line of the circulation processor water pump is lower than the lowest working water level of the water tank. Connect the inlet and outlet pipes of this product.
The installation place of the water tank self-cleaning sterilizer should be in a dry and ventilated place with rainproof and waterproof measures.
Make the water level exceed the center line of the water pump of the energy-release circulator, and turn on the main power supply to start the equipment.
When cleaning and maintaining the water tank pool, first cut off the main power supply of the equipment. When using again, please turn on the power according to the specified time.