Shanghai professional steel structure platform design and construction

>In steel structure engineering, steel structure platforms are widely used. Steel structure platforms generally consist of decking, primary and secondary beams, columns, inter-column supports, as well as ladders, railings, etc. The design and layout of the steel structure platform should meet the following requirements:
< r: >,
: : R> Meet the requirements of process production operations and ensure clearance for passage and operation. The general traffic clearance height should not be less than
>.
: : R>, and the width should not be less than
>.
:: R>, and should not be less than
>.< br/>: : R>. Protective railings should generally be installed around the steel structure platform, and the height of the railings is generally
>
: : R>. When the height of the platform is greater than
>
: : R>, a skirting board with a height of
>
: : R> should be set under the protective railing. The steel structure platform should be equipped with a ladder for up and down passage, and the width of the ladder should not be less than
>
: : R>.
< r: >,
: : R> When determining the plane dimensions, elevation, beam grid and column grid layout of the steel structure platform, in addition to meeting the usage requirements, the layout of the beams and columns should also consider the platform. equipment loads and other large concentrated load locations, as well as the hanging of large-diameter industrial pipes, etc.
< r> >
: : R>. The layout of the steel structure platform should be economical and reasonable, and the force transmission should be direct and clear. The layout of the beam grid should be suitable for its span. When the span of the beam is larger, the spacing should also be increased. Make full use of the allowable span of the decking and rationally arrange the beam grid to achieve better economic results.
< r: >,
: : R>Wherever possible, the beams and plates of the platform should be directly supported on factory columns, large equipment or other structures as much as possible to achieve economical purposes.
< r: >,
: : R>In order to facilitate manufacturing and make the components simple, hot-rolled steel should generally be used first for the main beams, secondary beams and columns of the steel structure platform. For beam components, it is better to use Hot-rolled I-beam or
>
: : R>-shaped steel is the most economical. When the force or span of the beam is so large that the use of shaped steel beams cannot meet the load-bearing capacity and stiffness requirements of the components, combined I-shaped cross-section welded beams are usually used.
< r>: : R>Headquarters address: Zhongshan North 1st Road, Hongkou District, Shanghai
>
: : R> Shanghai Office Building
>
: : R >Building No.
>
: : : R>Room
< r>: : R>Contact
: : : R>Contact
: : R>Person: Mr. Jin
< r>: : R>Mobile phone
>
: : R>Mobile phone:
>
< r>: : R>Electronic phone
>
: : R>Words:
>