Chongqing emery floor paint four-point material six-point construction

Emery wear-resistant floor material is composed of special wear-resistant aggregates, high-quality cement, special additives, etc. It is produced ready-mixed, with strictly controlled proportions and stable quality, and is directly applied on the construction site. The emery ground is constructed by dry sprinkling. After solidification with the concrete base, a dense, hard, highly wear-resistant and dust-proof surface layer is formed on the ground.
1. Requirements for base concrete
The strength of base concrete must be above 1. The water-cement ratio should be controlled below 1. The slump of concrete should be controlled to minimize segregation of the concrete mixture and reduce bleeding. control.
In order to ensure that the concrete mixture has sufficient fluidity and facilitates construction, it is recommended to add appropriate retarder to the concrete.
Pay attention to the corners of the concrete construction blocks and take additional strengthening treatments.
2. Plan coverage
Divide the ground into areas of a certain area.
. Prepare enough materials for two segmented constructions.
3. Note on the first stage of construction: High temperature or windy weather will accelerate the solidification of concrete and reduce the allowed construction time
Wait until the concrete solidifies (light pedestrian traffic leaves about 100 marks)
/> , excess surface bleeding needs to be evaporated or sucked away.
Tear approximately a total amount of material evenly onto the concrete surface.
4. Smooth
After the first tearing of the material, the surface turns dark, indicating that enough water has been absorbed from the base concrete.
Use a wooden trowel or a polishing machine with a grinding disc to smooth it.
Make sure all corners are completely compacted.
5. The second stage of construction
Tear off the ground hardener evenly in the direction perpendicular to the first stage.
Smooth it with an electric steel spatula or a disc polisher.
6. Polishing
When the concrete surface is hard enough and will not be damaged, use a polishing machine with a slightly tilted blade to smooth it and polish it.
, water or special curing agent for maintenance
Non-metallic aggregate wear-resistant floor editor
Scope of application
It is used for non-metallic aggregates that must be wear-resistant, impact-resistant, dust-reducing and suitable for non-metallic aggregates Concrete floors that meet the material requirements, such as: warehouses, docks, factories, parking lots, maintenance workshops, garages, warehouse-style shopping malls, etc.
Contact: Tang Min, Tel: br>