Type 860 corn peeling and threshing all-in-one machine corn peeling machine corn threshing machine

Processing and customization
Yes
Product type
Brand new
Applicable object
Corn
Applicable field
Agriculture
Type
Peeling Shell machine
Brand
Three pieces
Model
Feeding amount
Total loss rate
Weight
Manufacturer
Xingyang, Henan Province City Sanzhang Machinery Factory
Power type
Electric
Corn peeling and threshing machine that can be equipped with a tractor
Type corn peeling machine, corn peeling machine, corn peeling machine
< br/> Copy
Copy
Copy
Copy
Copy
Copy
Product details

The picture above shows the threshing shaft Net
The picture below shows a tractor-mounted bracket
Copy
Copy
Copy
A shaft-changing corn peeling and threshing machine that can be equipped with a motor or tractor
Type corn peeling machine corn peeling machine corn peeling machine
1. Working principle
The machine uses a single-phase two-stage four-stage motor as the power input main shaft assembly. Through gear transmission, the peeling machine is driven during operation. , the relative rotation of the two pairs of steel peeling rollers in the peeling chamber is adjusted by adjusting the adjustment screw under the rocker arm bearing seat. The two pairs of peeling rollers are in close contact with each other by the pressure of the spring. After the fruit ear enters the peeling chamber, the rigid The peeling claws on the peeling roller tear apart the bract leaves, and the two pairs of relatively rotating rollers roll the bract leaves. At the same time, the machine cover and the rubber adjusting plate on the cover press the ear during rotation, relying on the rotation of the two rollers. The force and the pressure of the spring pull open the bract leaves and separate them from the ear, so as to achieve the purpose of tearing the skin.
2. Use and general adjustment
To determine the tearing rate, adjust the adjusting nut at the lower end of the rocker arm bearing seat and press the tearing rollers together tightly by the pressure of the spring. When the tearing rate is low, turn the Tighten the adjusting nut, increase the spring pressure or adjust the rubber adjusting plate in the machine. There is an adjusting nut on the plate for adjustment.
During the peeling process, try to avoid vertical feeding of the bracts under the machine and the bare ears behind the machine, otherwise it will easily cause the bracts to wrap around their axis and block the outlet.
Warning
The bract leaves wind around the axis, affecting the peeling effect, and should be dealt with in time.
The feeding amount should not be too large, otherwise it will easily cause blockage and may lead to rotten grains.