Lechang City modeling ceiling light-transmitting film, Lechang City flame-retardant soft film ceiling

Lechang City Styling Ceiling Translucent Film Lechang City Flame-Retardant Soft Film Ceiling Manager Zhang Mobile Phone
Engineering Consulting
Keels are mainly used in building decoration for walls, cylinders, floors, doors, windows, ceilings, etc. Force frame for base material. The material of the keel is mainly wood, which is mostly used in the production of suspended ceilings and partitions.
Key points for selecting wooden keels
Fresh wooden keels have a slightly reddish texture and clear texture. If the color is dark yellow and dull, it means it is dead wood.
Check whether the specifications of the selected wood cross-section meet the requirements, whether the head and tail are smooth and even, and not of different sizes. At the same time, the wooden keels must be straight. Unflattened wooden keels can easily cause structural deformation.
Choose wooden keels with fewer knots and smaller knots. If the knots are large and there are many screws and nails, they will not be screwed in or the wood will be broken and the structure will be unstable.
To choose a dense and deep wooden keel, you can use your fingernails to pick out the promising wooden keel without leaving any obvious marks. Installation steps of Demei soft film ceiling
The first step of installation of Demei soft film ceiling is to fix a circle of support keels around the horizontal position where the soft film ceiling needs to be installed according to the drawing design requirements. Note: In some places where the area is relatively large, installation in blocks is required to achieve good results. In this case, a wooden square strip needs to be added in the middle. This is a practical process based on the actual situation. After all the required wooden strips are fixed, the aluminum alloy keel of the soft film ceiling is fixed and installed on the bottom surface of the supporting keel.
The second step in the installation of Demei soft film ceiling
After all the aluminum alloy keels for installing the soft film ceiling are fixed, install the soft film. First open the soft film and use a special heating air cannon to fully heat it evenly. Then use a special inserting knife to tighten the soft film and insert it onto the aluminum alloy keel. Finally, trim the excess soft film around it completely.
Use after installation Use a clean towel to clean the soft membrane ceiling.
Demei Soft Membrane Ceiling strives to do better and hopes to help you.