Small household rice huller, rice mill, commercial sheller, sheller, green nutritious rice, brown rice machine

The use of paddy huller (brown rice machine)
1. Purpose: This machine is mainly used for hulling rice and can separate the rice husk from the paddy
and coarse mixture.
_Customized content area. 2. Structure: This machine consists of a hopper feed switch, a speed and slow rubber roller separator,
a gear box, etc.
3. Installation: The machine should be installed with anchor screws and leveled.
.The motor switch should be installed with a blade, and the motor should be reliably grounded.
Before starting the gearbox, the breathable cap must be removed, add No. or No. industrial gear oil (-) to the oil level (approximately.),
then tighten the breathable cap.
.4. Preparation work:
.The rice to be processed should be cleared of weeds, sand, gravel, metal and other foreign matter.
.Adjust the rubber roller rolling distance. The rolling gap should be about .~mm. First loosen the locking handle, rotate the distance-adjusting handwheel clockwise to make the slow roller leave the fast roller, then insert the rolling distance plate between the fast and slow rollers, and rotate the distance-adjusting handwheel counterclockwise to make the The slow roller is close to the fast roller. When the rolling distance plate can be pulled out freely and there is friction with the rubber roller, the gap is adjusted. Finally, use the locking handle to tighten the distance adjustment hand wheel.
.5. Usage:
..Start the machine and observe whether there are any abnormal friction and collision sounds
If there is any abnormality, stop the machine immediately for inspection. After idling is normal, turn off the feed
>Switch, pour the cleaned rice into the hopper, slowly turn on the feed switch
, if there is no abnormality, adjust it to the appropriate size and then lock the feed switch. During use, safety protection devices must be installed for personal safety. It is not allowed to extend your hands into the machine to avoid personal injury.
..Check the quality of rice hulling and brown rice. The first shelling rate should be about 10%, and the brown rice should not be broken or stained black. If it is found that the brown rice is broken or dyed black, the pressure regulating spring should be loosened appropriately to reduce the pressure between the fast and slow rollers. If the shelling rate cannot be reached, the pressure regulating spring should be tightened appropriately, but the brown rice should be ensured that there are no broken skins, black stains, etc.
.Check the separation of rice after husking. Generally, the amount of husk in brown rice should not be greater than that. Brown rice is not allowed in the husk. If the husk content is greater than
, the air volume of the separator should be increased. If brown rice is blown out of the rice husk, the air volume should be turned down.
.When the rubber roller is half worn, the fast and slow rollers should be replaced before use. When the rubber roller exposes the iron core, a new rubber roller should be replaced at the same time. When installing the rubber roller, pay attention to the alignment of both ends. The gap between the two end surfaces of the rubber roller and the two solid plates should be even. The gap between the two ends is ~.mm. After adjustment, the rubber roller is tightened with screws. .
.The gearbox oil level should be checked frequently during use. When the lubricating oil is lower than the oil mark, the lubricating oil should be added to the height of the oil mark. Under normal circumstances, the original gear oil should be drained out of the gearbox every six months, filled with kerosene up to the oil mark, then cleaned for 3 minutes before draining out the clean kerosene, and refilled with industrial gear oil (-) to Oil mark center line
Check the two bearing caps at the rubber roller and the bearing cap at the pulley once a month, and add butter. Clean the bearing with gasoline every six months and add new butter.
..Frequently check whether the ventilation hole of the breathable cap is blocked. If there is dirt, it should be cleared in time to maintain normal ventilation of the gear box.


r: rRice handling capacity
r (varies with different rice varieties)
r Rubber roller specifications
r .
r Spindle speed
rfast rollerr/slow roller
rmatching power
r-level single motor
rmotor frequency
r .
.
rMotor voltage

rOutline dimensions
r (length, width and height)
rComplete machine weight
rAbout kilograms. With motor, about kilograms