American Bell BeII801 alkaline reverse osmosis scale inhibitor

Special alkaline scale inhibitor for reverse osmosis
Product Overview and Application
It is a highly efficient scale inhibitor specially developed for reverse osmosis (r) systems. The formation of scale and scale on the reverse osmosis membrane can deteriorate the performance of the water treatment system and require premature replacement of the reverse osmosis membrane. The accumulation of dirt and sediment on the reverse osmosis membrane will cause deterioration of permeability, reduced permeability, frequent shutdowns, increased water consumption, and increased energy consumption.
Suitable for salt solutions with a value of . and a silica content less than / at a temperature of
°C.
Physical Properties
The following physical properties are typical values. Please see the Material Safety Data Sheet (D) for the latest data.
<= dd Color:
Transparent yellow
Physical state:
Liquid
Odor:
Slight ammonia smell
Density:
.lb/gallon
Specific gravity (°C)


<= dd value (pure form):
Freeze-thaw recovery:
Complete
Viscosity (℃)

Flash point
None
Water solubility:
Completely dissolved
Freezing point:
No data
Volatile organic compounds:
No data

Regulatory status
This product has received/international certification for the reverse osmosis antiscalant category in/standards. Its official name is various water supply products. The maximum dosage is/.
Only products with the / logo on the packaging can be used for drinking water treatment.
Material Compatibility
<= dd Compatible Materials
Incompatible Materials
Stainless Steel
Brass
Chlorinated Polyvinyl Chloride
Neoprene
Polyethylene
Fluorine rubber
Polypropylene
Butadiene rubber

Polyurethane

Ethylene-propylene- Diene copolymer (D)

Chlorosulfonyl polyethylene synthetic rubber

Product dosing
Usually a dilution ratio of up to
times is used . If a higher dilution ratio is used, special attention should be paid to the state (cleanliness) of the antiscalant storage container and the solution should be prepared again every day.
.Can be added to the diluent to increase the value to - It is especially recommended to be used in warmer environmental conditions to prevent the growth of microorganisms.
The dosage depends on the chemical properties of the feed water, membrane type and system operating parameters (such as recovery rate, temperature and pressure, etc.). These parameters determine the fouling species that may cause membrane module fouling. It is recommended to use special antiscalant calculation software to select the optimal dosage. This software can select the appropriate antiscalant and calculate the appropriate dosage based on the design and operation of the r system and the chemical characteristics of the inlet and concentrated water ends. The software is easy to use and automatically calculates various results.
Safety and Handling Precautions
Please see Material Safety Data Sheet (D) Chapter Personal Protection before application