Decorative tile bonding strength drawing instrument Decorative tile drawing instrument Insulation material drawing instrument

Decorative tile bonding strength tester Ceramic tile pullout instrument 1. Overview
It is used to test the bonding strength of veneer tiles and exterior wall insulation materials. It is an ideal tool for construction units, engineering quality inspection stations (centers), laboratories, and scientific research institutes. It has been widely used by supervision units, etc. and is welcomed by the majority of engineering and technical personnel.
2. Main technical parameters
, maximum pull-out force
, piston stroke
, chassis and point inner diameter
, digital display resolution
, indication value The error is less than %
, weight (host)
3. Applicable standards
"Inspection Standard for Bonding Strength of Decorative Bricks in Construction Engineering"
"Construction and Acceptance Regulations for Exterior Wall Decorative Bricks Project"
"Technical Regulations for Exterior Wall Insulation Engineering"
"Exterior Wall Insulation System of Rubber Powder Polystyrene Particles"
"Exterior Insulation System of Expanded Polystyrene Board Thin Plastering for Exterior Walls"
4. Features
High precision and minimum measurable force value.
. High efficiency. Compared with the traditional pressurization method, the pressurization speed of this detector can be nearly doubled, completely reducing the detection fatigue caused by improper pressurization structure.
, using software calibration, no need to disassemble.
5. Operating Procedures
Connect the threaded pull rod to the preset standard block, install the detector, turn on the power switch of the pressure gauge, press the clear key to display for a few seconds, and the instrument will automatically Clear.
. Turn the handle clockwise, and the piston will rise approximately. When it is in quick contact with the tie rod nut but is not stressed, if the displayed value changes and is not zero, press the clear key again to reset the friction in the hydraulic system. The value is subtracted and displayed on the LCD screen. The pressure gauge automatically completes the zero adjustment. Continue to turn the handle and gradually increase the pulling force on the standard block. When the ultimate pulling force is reached, the standard block separates from the measured body. At this time, the maximum pulling force value is maintained. Press Storage key The value is stored in the instrument.
After the inspection is completed, reverse the handle to retract the piston, and remove the tie rod and standard block.
6. Precautions and Maintenance
When using the instrument, attention should be paid to shockproof, moisture-proof and strong pulling between the connecting wire and plug.
When the digital pressure gauge displays, it should be charged in time. The charger must be a special type for this instrument, and the diameter should be used when charging. Large convex plug for connection and charging.
Always keep the testing instruments and accessories clean. If necessary, add lubricating oil to the rotating parts. The hydraulic system should be filled with clean anti-wear hydraulic oil or engine oil with similar indicators.
7. Main functions
Suitable for testing rivet pullout force and bonding strength of thermal insulation materials.
, rivet pullout force testing, insulation material bonding strength testing (test blocks of different specifications).
, the peak value is maintained in the peak value hold state, and the maximum pulling force value is always displayed.
8. Basic configuration
, one host machine (including high-precision sensing and detection unit)
, one intelligent digital peak hold meter
, one sensor connecting wire
>, two sets of three standard blocks (/)
, one instruction manual
, one set of industry standards
, one aluminum alloy (leather) packaging box
, qualified One certificate and one warranty card each