Cement anti-pressure clamp Cement anti-pressure clamp Cement anti-pressure clamp

.>< c=>Cement pressure-resistant clamps
.>
.>< c=>1. Standard basis for cement pressure-resistant clamps:
.>
. >< c=>Manufactured in accordance with my country’s building materials industry standard C/. It is a unified equipment specified in the national standard & Cement Mortar Strength Test Method (Law) B/&, and is used to test the compressive strength of cement.
.>< c=>Now all are new standard products, the specifications are
.>
.>< c=>2. Cement compression clamp
.>< c= >Main technical parameters:
.>
.>, length of upper and lower platens
.>
.>, width of upper and lower platens
.>
.>, free distance of upper and lower platens
.>
.>, overall dimensions*
.>
.>, net weight
.>
.>< c=>3. Cement compression clamp
.>< c=>Structural features:
.>
.>< c=>Mainly composed of lower clamp base and upper clamp base , standard clamp roller, anti-splitting clamp upper and lower pressure strips. The lower clamp base is fixed on the press piston through positioning pins and washers, and the upper clamp base is fixed on the press beam through the upper support, diamond pins, positioning pins on the press and two hexagon socket screws.
.>
.>< c=>4. Cement compression clamp
.>< c=>Notes:
.>
.>Check before use Check the limit size to see if it still maintains the correct position
.>
.>If the stop pin is worn out of tolerance, it can be repaired by grinding. If the baffle, latch, and positioning taper pin are worn out in tolerance, it can be reassembled. Continue to use after staggering the worn parts
.>
.>< c=>5. Cement pressure-resistant fixture
.>< c=>Inspection method:
.>
.>, Visually inspect the appearance. Cement pressure-resistant fixtures should be protected and clean, free from bumps and scratches, and should have a firm nameplate.
.>
.> The upper and lower pressing plates should be made of hard steel, with a length of &., a width of &, and a thickness of &.
.>
.>, The plane tolerance of the entire contact surface between the upper and lower pressure plates and the specimen is ., and the free distance between the upper and lower pressure plates is &.
.>
.>. The center of the ball seat on the upper pressure plate should be at the intersection of the central axis of the fixture and the lower surface of the upper pressure plate. The tolerance is &. The upper pressure plate will automatically level as it contacts the test piece. .
.>