10 safe operating procedures for small shot blasting machines

General safety operating procedures for small shot blasting machines. There are different types of shot blasting machines. Let’s talk about the safe operating procedures for crawler shot blasting machines:
Before using the crawler shot blasting machine, check all aspects of the machine. The operation and wear conditions of the components. If serious wear is found, please perform maintenance in time, because damaged equipment is most likely to cause safety accidents
All lubrication points of the crawler shot blasting machine should be lubricated on time, and the reducer should be lubricated on time. Also fill in oil
Before operating the crawler shot blasting machine equipment, you should check whether all switches are safe and reliable
All operators must be proficient in the operating procedures of the equipment before they can perform on-site operations. Non-professionals No one is allowed to enter
During the operation, special attention should be paid to loading and unloading to prevent the workpiece from falling out due to high-speed rotation and causing injury accidents. When loading, the actual situation should be taken into consideration, and on the basis of ensuring that there is a certain amount of space for the workpiece to be cleaned. Adjust the amount of material added, and the amount of material added cannot exceed the specified range of the shot blasting machine
The cleaning room door can only be opened after the crawler shot blasting machine has completely stopped working. The power supply must also be cut off for maintenance of the crawler shot blasting machine.
If the guard plate or rubber track inside the crawler shot blasting machine is cracked or severely worn, it should be replaced in time to prevent projectiles from flying out
The surroundings of the crawler shot blasting machine Scattered projectiles should be cleaned up at any time to prevent operators from slipping. Timely check the wearing parts of the crawler shot blasting machine, including blades, impellers, fixed sleeves, shot blasting wheels, etc., clean castings with oil stains on the surface on time, and clean the separator at the same time. Impurities on the screen.
After the work of the crawler shot blasting machine is completed, immediately cut off the power switch of the machine to prevent the equipment from running.