JS30 reducer

齿数：

11-44

功 率：

0.18KW～15KW

转 矩：

1.5N·m～2062N·m

Reducer
Reducer, also called reducer, is suitable for type/type scraper conveyors used in coal mines. This reducer is mainly used as a kilowatt reducer for mining scraper conveyors.
This reducer is a three-stage spiral cylindrical gear reducer. The reducer is installed on the side of the conveyor head frame and arranged parallel to the conveyor. The four shafts of the reducer are the output shafts, and the splines of the four shafts drive the conveyor sprocket. The first shaft of the reducer is connected to the motor through a coupling to complete deceleration and power transmission.
The reducer is a three-stage reduction, involute gear transmission. The total transmission is... The first stage is an arc bevel gear, the second stage is a cylindrical helical gear, and the third stage is a cylindrical spur gear. The technical parameters of gears at all levels are shown in the table.
Total number of stages, tooth module, helix angle transmission ratio
Transmission ratio of each stage, total transmission ratio
First stage
Second stage&
Third stage
The axial clearance of each axis of the reducer is the first axis.~., the second axis.~., the third axis.~., the fourth axis.~
The structure of the reducer is larger than that of the general mining cone, The cylindrical gear reducer has been greatly improved. The first shaft uses a set of double-row radial spherical roller bearings and two sets of single-row radial ball bearings. The axial force generated when the arc bevel gear rotates is borne by two sets of single row radial ball bearings. Double row radial ball roller bearings rely on splash lubrication. Two sets of single row radial thrust ball bearings are lubricated with sodium-based grease. The axial position and axial clearance of the shaft arc bevel gear are ensured by adjusting the adjustment pads at both ends of the single row radial thrust bearing.
The reducer box is symmetrical up and down to meet the different needs of left and right work underground. When replacing the left and right working surfaces, an air plug must be installed on the upper cover and an oil plug must be installed on the lower cover. The reducer uses No. 1 extreme pressure gear oil or No. 1 hyperbola gear oil to lubricate the gears. The injection amount is the tooth width of the immersed large bevel gear.
Conical planetary gear reducer, conical cylindrical planetary gear reducer
Create value for customers and grow together with the enterprise.
Factory address Liying Industrial Park, Rencheng District, Jining City, Shandong Province
Consultation phone number
Online