Manufacturer specializing in the production of putty insulation mortar rubber powder quotation

Manufacturer specializing in the production of putty insulation mortar rubber powder quotation
b During the manufacturing, transportation and use of the product and after use, it is not only non-toxic to the human body and the environment, but also harmful to the living environment
b Environmental protection of the ecological environment A virtuous cycle goes a long way.
In the sealed state, the quality of the resin powder will not change if it is placed in a climate environment of
℃
and
℃
.
<>
It can improve the ease of scraping and polishing of mortar, and effectively improve the initial adhesion, later strength, service life and stability of mortar.

<>
How to use
<>
The method of using resin rubber powder is very simple. Just add water directly to the construction site and mix evenly. The mortar water

/
Leave it for ten minutes before use. When the bonding thickness is
mm and the polystyrene board bottom layer mortar thickness is
mm thick, it is forbidden to construct at the following temperatures. The solidification bonding effect can be fully achieved in
days. The dosage is
㎡.
<>
Notes
<>
The first resin rubber powder feeding should not be put in at one time, it must be divided into sub-components in order to find the most suitable amount
.
<>
Secondly, when polypropylene fiber needs to be added, it must be dispersed in cement first, because the fine particles of cement can eliminate the static electricity of the fiber so that the polypropylene fiber can be dispersed.
<>
Third, stir and mix evenly, but the stirring time should not be too long,
minutes is appropriate. Mixing sand and cement for a long time will easily precipitate and stratify.
<>
Fourthly, it is necessary to adjust the dosage of additives and add appropriate amounts
according to seasonal changes.
<>
Fifth, avoid additives or cement from getting wet and clumping.
<>
Sixth, it is strictly prohibited to mix and stack with acidic substances.
<>
Seventh
℃
It is prohibited to use it in construction below ℃. Low temperature construction will cause the biggest project quality problems, causing the plastering mortar and the insulation board to not bond. This is There is no remedial solution for project quality issues at a later stage.

<>
manufacturers specializing in the production of putty insulation mortar rubber powder quotation