Concrete vibrating table | Vibrating table wholesale | Vibrating table manufacturer | Cement vibrating table | Vibrating table

Concrete vibration table|Vibration table wholesale|Vibration table manufacturer|Cement vibration table|Vibration table
Overview
Concrete vibration table is suitable for laboratory, on-site worksite for specimen forming and prefabricated component vibration. Vibration forming of various slabs, columns, beams and other concrete components.
Working Principle
The concrete vibration table is mainly composed of the table base, vibrator spring and other components. The table and base are welded with steel plates and shaped steel. The vibration table uses a motor plus a pair of identical eccentrics. composed of wheels. And it is installed at the center of the table (reverse side) through a pair of hanger couplings, which plays a stable and vertical role during the vibration process.
The vibration table complies with national standards such as /, etc.
Main specifications
Table size* type* type* type
Main technical indicators
Kilowatt watts custom vibration table common power watts kilowatts
Debugging and installation methods
Lifting
There are four holes on both sides of the table and bottom frame, which are lifting holes. When transporting the whole machine, use the four lifting holes on both sides of the bottom frame for transportation of the whole machine. When disassembling the tabletop, use four lifting holes on both sides of the tabletop. The lifting device hooks should be inserted into the holes first, and the tabletop should be raised about 100 degrees to make the movable tabletop and the positioning pins under the chassis separate. Then the tabletop can be lifted. .
Installation
Before installing the vibrating table, four anchor bolts should be poured and buried on the cement foundation according to the location and size diagram of the anchor bolts. The plane on the cement foundation must be leveled. Then fill in the vibration-absorbing rubber pad, and make sure the chassis is level when installing the chassis and tightening the fixing bolts. Before installing the movable table, fill the upper part of the chassis with hard rubber. After the table and the chassis are installed, if you find that the four corners of the table are uneven, you can add thin rubber to the uncompressed rubber cushion until it is evenly pressed around the table.
Instructions for use
Before installing the vibrating table, the foundation should be laid first. When laying the foundation, the upper plane should be found horizontally and the fixing bolts should be buried according to the bolt holes of the bottom beam, and then installed. The fixing bolts must be installed during installation. Tighten.
. Before the vibration table is installed and tested, drive it for a few minutes and then stop the machine. Check all fastening bolts. If they are loose, they must be tightened before use.
During the vibrating table cloth vibration process, the concrete products should be firmly fastened to the vibrating table. The products to be vibrated should be placed symmetrically with the table to balance the load. Users can adjust the fastening device of the vibrating products according to Design and prepare by yourself according to your own needs.
The vibrator bearings should be inspected frequently, disassembled and cleaned regularly, and the lubricating oil should be replaced to keep the bearings well lubricated and extend the service life of the vibrator.
The vibrating table should have a reliable grounding wire to ensure safety.
Operating Procedures
Before using the vibrating table, it is necessary to test-run it. First, drive the machine with no load, then stop and tighten all fastening parts, repeat it several times before it can be officially put into operation.
When the vibrating table is used in production, the test mold of the concrete specimen must be firmly fastened to the workbench, and the test mold must be placed symmetrically with the center line of the table to balance the load.
The vibration motor should have a good and reliable ground wire.
If abnormal noise is found in the vibration table during the production process, it should be stopped immediately, unplug the power supply and comprehensively check whether the fastening parts are loose. If necessary, check whether the eccentric block in the vibration motor is loose or the parts are damaged, and tighten the loose parts. parts, replace damaged parts.
After use, turn off the power and clean the vibrating table.
Contact number