Intelligent module CPA-101|220|380|Electronic actuator

型号：

CPA101-220/380

电源：

AC220

精 度：

1%

Intelligent module ||| Electronic actuator
The functions of each function selector switch are as follows
The status selector switches ① and ② are selected to turn on ① and off ②. When the input signal is added to, the output signal is turned on ② , disconnect ① When the input signal is added from to, the output signal is from to
The selection of status selection switch ③④⑤ is disconnected ③, ④ is connected ⑤ When the input signal is disconnected, the output shaft stops in the original position. Disconnect ④, ⑤ connect ③ When the input signal is disconnected, the output shaft rotates to the fully open limit switch and then stops. Disconnect ③, ⑤ connect ④ When the input signal is disconnected, the output shaft rotates to the fully closed limit switch and then stops.
When inputting the signal for selection of status selection switch ⑥, turn switch ⑥ on.
When using input signal, turn off switch ⑥. Each status selector switch is turned on when it is turned to the right end, and turned off when it is turned to the left end. If the output signal terminals ③ and ④ are not wired, please short-circuit them with a resistor
The main models are
,,
Must-read for control module replacement and installation
Precautions for installation of control module< br/> ◆Please carefully check whether the actuator and valve have any mechanical jamming problems between replacing and installing modules! Installation can only be done after confirming that there is no jamming. Inspection method: After the power is turned off, manually turn the valve to fully open and then fully close to confirm that there is no jamming of the machine.
◆When replacing the wiring, be sure to cut off the power supply before performing the wiring operation!
◆Please confirm whether the module status switch is correct before replacement or installation. (Status switch,,closed,,,opened is the correct state).
◆ Please strictly follow the module wiring instruction label when wiring. Wrong wiring is strictly prohibited!
◆Please adjust the zero point and stroke potentiometer accurately (the sensitivity adjustment potentiometer has been set before leaving the factory. There is no need to adjust it if there are no special requirements)