Physical picture of mining electric rake manufacturer

长×宽×高：

3200×1200×1400mm

轨距：

600mm

规格：

标准

This year is coming again. Zhang Mao, director of the State Administration for Industry and Commerce, said at the two sessions that the cost of breaking the law for companies producing counterfeit and shoddy products is too low. These companies must be restricted everywhere, or even fined to the point of bankruptcy. After reading this sentence, I was quite touched. Credit construction does require such iron means! Jining strives to produce conscientious products with excellent quality and reasonable prices, ensuring that you are satisfied with your purchase and comfortable in use. Mining electric rakes are mainly used for ore handling and filling work in pits or open air in metal mines and other mines. It is mainly used for horizontal rake transportation, and can also be used for rake transportation on slopes with small inclination angles. It cannot be used as lifting equipment. The driver can operate it by hand next to the winch, or use a button to perform distance control a few meters or even tens of meters away from the winch.
The electric rake for mining uses a wire rope wrapped around the drum to pull the rake bucket in a reciprocating motion to rake and transport materials.
The electric rake for mining is composed of three main parts: winch, rake bucket and pulley.
Mining electric rakes are mainly used in pits and open spaces in metal mines and other mines for raking and filling minerals on horizontal and gently sloping working surfaces.
The main components of the electric rake for mining
The electric rake for mining has a reduction device, a main drum, an auxiliary drum, a control device, a steel rope guide device and an electric motor. These components are installed inside and outside the shell respectively. The shell is a component with good rigidity, which not only protects and supports, but also bears all loads. It is bolted to two slides connected to the foundation. The two-cylinder winch has one main drum (installed on the right side, that is, the side close to the motor and one auxiliary drum (installed on the left). The three-cylinder winch has one main drum (installed on the middle) and two auxiliary drums (installed on the left side). On the left and right). The three-drum winch can also be equipped with two main drums (installed on the right side and an auxiliary drum in the middle (installed on the left side). Each drum has a corresponding control device and a wire rope guide device.
Product classification and model significance of electric rake for mining
Models of electric rake for mining include,,.
Contact Manager Zhang
Tel
Mobile phone
Address Shandong Yutai County Development Zone, Jining City, Province