Sticky steel reinforcement MT-101 sticky steel glue

Order consultation phone Product Features
This product is in liquid form and is easy to repair small cracks in concrete.
After the buildings and structures are damaged, their integrity can be effectively restored after being reinforced with glue, and the appearance will not be damaged.
, This glue does not contain volatile solvents and basically does not shrink when cured.
, has good toughness and impact resistance.
, long operating time and high bonding strength after curing.
, has good resistance to water, oil, alkali and dilute acid media.
Scope of application
It is used for pouring and repairing cracks in reinforced concrete, and filling and repairing cracks in concrete walls, floors and basements.
, widely used in outsourcing steel bonded steel reinforcement projects.
Construction Instructions
The surface of the steel plate and the concrete pasting surface should be surface treated. The surface of the steel plate should be derusted and the surface of the concrete should be polished.
, then weigh out the proportion of component A and component B and pour it into the container, stir until the color is uniform (usually 10 minutes)
That's it. In winter or when the temperature is low, component A and B It can also be operated according to the ratio of , for example, if the ratio of A to B is used, the operating time will be shortened. (Note that when stirring two-component glues A and B, the same stirring rod cannot be used at the same time.)
The amount of glue stirred each time should not exceed kilograms, and kilograms are appropriate.
. Carry out pouring construction according to the requirements of the design drawing, and seal the wall with cement at various parts that are prone to adhesive loss to prevent
glue loss.
. When choosing pressure injection glue, the pressure of the general pressure pump should be the maximum and should not exceed
. The minimum operating temperature of the glue is ℃. If it is lower than this temperature, necessary temperature-raising measures should be taken.
Packaging and transportation
This product is packed in iron drums. The small packaging specification is kilograms + kilograms/group, and the large packaging specifications are (barrel)
+ (barrel)/group.
This product is not a flammable and dangerous product and can be transported by air, sea, railway and road.
This product should be handled with care during transportation, loading and unloading, protected from rain, explosion and sun, and must not be turned upside down.
, Storage time: The glue has been stored at room temperature for one year, and there is no obvious change in any performance.
Component B is prone to discoloration during long-term storage, which is normal and does not affect the basic performance and use of the product.