QJ-1 Wall Brick Magnetic Vibration Table Wall Brick Vibration Table Wall Brick Trial Mold Wholesale Price

Wall Brick Magnetic Vibration Table Double Spring Wall Brick Vibration Table Wall Brick Vibration Table Wall Brick Trial Mold Wholesale Price
1. Product Introduction:
Wall Brick Magnetic Vibration Table is a An updated and improved product based on the ordinary vibrating table. The appearance specifications of this product are that the weight is .. times that of the original ordinary vibrating table. There is a disk attached under the table. When the power is turned on and the magnet is applied, the suction force of the disk can reach about kilograms. The magnetic force will disappear automatically after the power is turned off. This not only eliminates the need to lay a foundation during installation, but also solves the problem of fastening the specimen to the table during the experiment. And the switch is equipped with a timing device, making it easier and more convenient to use.
2. Structural principle:
The vibrating table is mainly composed of disk, table, chassis, vibrator, spring and other components, which are integrated by welding. The vibrator is located at the center of the bottom of the table. It plays the role of stabilizing and stabilizing.
3. Specifications and technical parameters:
, Table size: , Vibration frequency: minutes, Amplitude:
, Vibrator power: , Maximum load:
4. Installation and use:
There is no need to lay a foundation, but the ground where the vibration table is placed must be flat to avoid inaccurate eccentric vibration data.
, power voltage (three fires and one zero), the ground wire must be connected, and always check whether the bolts on the vibrator are loose.
According to the technical requirements, a flat-bottom test mold must be put on the stage, and the placement must be symmetrical with the table to balance the load, and pay attention to the fixed-point magnetic position. If there is no flat-bottom test mold, the floor of the test mold must be polished first, then loaded with materials and then placed on the table (but the effect is still not as good as the flat-bottom test mold).
5. Instructions for using the time controller:
, How to use:
, Connect the input and output lines according to the markings on the instrument (). Set the time dial switch to the required value. The unit is seconds.
b. Turn on the power switch, the indicator light is on, and the timing display indicates that the instrument is working normally and is in a waiting state.
Press the start button, then the vibration table starts to work. When the displayed time is equal to the set time, the instrument will automatically stop and brake. The work will be completed in about seconds.
If it works again, you need to press the start button again. If you need to stop the machine during exercise, you need to press the pause button and the instrument will automatically brake.
, Note:
, Do not connect the power supply electromagnetic motor output and input wires incorrectly.
b. During the stopping and braking process, it is strictly prohibited to start. It can only be started after braking is completed to avoid damaging the machine.
During use, if the continuous transportation time is too long, the table temperature is likely to overheat. It should be stopped for cooling before continuing to work, otherwise the electromagnetic effect of the disk will be easily damaged.
During the operation of the instrument, the dial switch cannot be moved to avoid affecting the timing accuracy.
After the vibration is completed, the power of the instrument should be turned off to prevent malfunction.